On Wed July 8 2009, Alan Stern wrote: > On Wed, 8 Jul 2009, Michael S. Zick wrote: > > > But, then again, we might just get lucky: > > ehci_hcd 0000:00:10.4: Unlink after no-IRQ? Controller is probably using the wrong IRQ. > > usb 1-5: khubd timed out on ep0in len=18/64 > > Like I've been telling you all along, the hardware isn't working. I > suspect it's worse than a simple interrupt-routing mistake. > > > > > For more information enable CONFIG_USB_DEBUG and CONFIG_DEBUG_FS, then > > > > see what's sitting in the usb/uhci/* files in debugfs. > > > > > > > > Anything in particular to look for/at? > > Just post the contents of those files. > Done: root@cb01:/sys/kernel/debug/uhci# cat * Root-hub state: suspended FSBR: 0 HC status usbcmd = 0048 Maxp32 CF EGSM usbstat = 0020 HCHalted usbint = 0002 usbfrnum = (1)4a8 flbaseadd = 19c7f000 sof = 40 stat1 = 0480 OverCurrent stat2 = 0480 OverCurrent Most recent frame: 52a (298) Last ISO frame: 52a (298) Periodic load table 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 Total: 0, #INT: 0, #ISO: 0 Root-hub state: suspended FSBR: 0 HC status usbcmd = 0048 Maxp32 CF EGSM usbstat = 0020 HCHalted usbint = 0002 usbfrnum = (1)4a0 flbaseadd = 19c63000 sof = 40 stat1 = 0480 OverCurrent stat2 = 0480 OverCurrent Most recent frame: 528 (296) Last ISO frame: 528 (296) Periodic load table 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 Total: 0, #INT: 0, #ISO: 0 Root-hub state: running FSBR: 0 HC status usbcmd = 00c1 Maxp64 CF RS usbstat = 0000 usbint = 000f usbfrnum = (0)c1c flbaseadd = 19c9c000 sof = 40 stat1 = 0495 OverCurrent Enabled Connected stat2 = 0495 OverCurrent Enabled Connected Most recent frame: 56aee (750) Last ISO frame: 56aee (750) Periodic load table 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 17 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 Total: 17, #INT: 1, #ISO: 0 And, at no extra cost: root@cb01:/sys/kernel/debug/ehci/0000:00:10.4# cat * size = 256 bus pci, device 0000:00:10.4 EHCI Host Controller EHCI 1.00, hcd state 4 ownership 01000001 linux SMI sts/enable 0xe00f0000 structural params 0x00103206 capability params 0x00006872 status 100f Halt FLR PCD ERR INT command 010008 (park)=0 ithresh=1 period=256 HALT intrenable 37 IAA FATAL PCD ERR INT uframe 14db port 1 status 701000 POWER sig=se0 port 2 status 701000 POWER sig=se0 port 3 status 701000 POWER sig=se0 port 4 status 701000 POWER sig=se0 port 5 status 703802 POWER OWNER sig=j CSC port 6 status 703802 POWER OWNER sig=j CSC irq normal 0 err 0 reclaim 0 (lost 20) complete 0 unlink 20 Mike > Alan Stern > > -- > To unsubscribe from this list: send the line "unsubscribe linux-kernel" in > the body of a message to majordomo@xxxxxxxxxxxxxxx > More majordomo info at http://vger.kernel.org/majordomo-info.html > Please read the FAQ at http://www.tux.org/lkml/ > > -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html