[PATCH v2] Bluetooth: btusb: Reset port on cmd timeout

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



QCA_ROME sometimes gets into a state where it is unresponsive to
commands. Since it doesn't have support for a reset gpio, reset the usb
port when this occurs instead.

Signed-off-by: Abhishek Pandit-Subedi <abhishekpandit@xxxxxxxxxxxx>
---
On Chromebooks with this chipset, we encountered cmd_timeout after
running suspend stress test for hundreds of iterations. Without
a recovery mechanism, continued cmd_timeout failures eventually caused
the suspend stress test to fail.

This change will just reset the port that the Bluetooth chip is on when
cmd_timeout is encountered. At the very least, the driver will unload
and stop affecting suspend. It doesn't seem to restore the BT controller
to a good state however (this still requires a power cycle).

Changes in v2:
- Renamed btusb_generic_usb_cmd_timeout to btusb_qca_cmd_timeout
- Updated commit note

 drivers/bluetooth/btusb.c | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index e42fdd625eb023..df46b2a34c1803 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -573,6 +573,22 @@ static void btusb_rtl_cmd_timeout(struct hci_dev *hdev)
 	gpiod_set_value_cansleep(reset_gpio, 0);
 }
 
+static void btusb_qca_cmd_timeout(struct hci_dev *hdev)
+{
+	struct btusb_data *data = hci_get_drvdata(hdev);
+	int err;
+
+	if (++data->cmd_timeout_cnt < 5)
+		return;
+
+	bt_dev_err(hdev, "Multiple cmd timeouts seen. Resetting usb device.");
+	err = usb_autopm_get_interface(data->intf);
+	if (!err)
+		usb_queue_reset_device(data->intf);
+	else
+		bt_dev_err(hdev, "Failed usb_autopm_get_interface with %d", err);
+}
+
 static inline void btusb_free_frags(struct btusb_data *data)
 {
 	unsigned long flags;
@@ -3964,6 +3980,7 @@ static int btusb_probe(struct usb_interface *intf,
 	if (id->driver_info & BTUSB_QCA_ROME) {
 		data->setup_on_usb = btusb_setup_qca;
 		hdev->set_bdaddr = btusb_set_bdaddr_ath3012;
+		hdev->cmd_timeout = btusb_qca_cmd_timeout;
 		set_bit(HCI_QUIRK_SIMULTANEOUS_DISCOVERY, &hdev->quirks);
 		btusb_check_needs_reset_resume(intf);
 	}
-- 
2.27.0.111.gc72c7da667-goog




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux