xHCI's PCI fixup, run at the end of pcie-brcmstb's probe, depends on
RPi4's VideoCore firmware interface to be up and running. It's possible
for both initializations to race, so make sure it's available prior to
starting.
Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@xxxxxxx>
Reviewed-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
drivers/pci/controller/pcie-brcmstb.c | 15 +++++++++++++++
1 file changed, 15 insertions(+)
diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index 3a10e678c7f4..a3d3070a5832 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -28,6 +28,8 @@
#include <linux/string.h>
#include <linux/types.h>
+#include <soc/bcm2835/raspberrypi-firmware.h>
+
#include "../pci.h"
/* BRCM_PCIE_CAP_REGS - Offset for the mandatory capability config regs */
@@ -917,11 +919,24 @@ static int brcm_pcie_probe(struct platform_device *pdev)
{
struct device_node *np = pdev->dev.of_node, *msi_np;
struct pci_host_bridge *bridge;
+ struct device_node *fw_np;
struct brcm_pcie *pcie;
struct pci_bus *child;
struct resource *res;
int ret;
+ /*
+ * We have to wait for the Raspberry Pi's firmware interface to be up
+ * as some PCI fixups depend on it.
+ */
+ fw_np = of_find_compatible_node(NULL, NULL,
+ "raspberrypi,bcm2835-firmware");
+ if (fw_np && !rpi_firmware_get(fw_np)) {
+ of_node_put(fw_np);
+ return -EPROBE_DEFER;
+ }
+ of_node_put(fw_np);
+
bridge = devm_pci_alloc_host_bridge(&pdev->dev, sizeof(*pcie));
if (!bridge)
return -ENOMEM;
--
2.25.1
