Hi Markus,
On Thu, Jan 09, 2020 at 05:29:07PM +0100, Markus Reichl wrote:
> Hi,
>
> I'm working with a ROC-RK3399-PC arm64 board from firefly, circuit sheet [1].
> The board is powered from an USB-C type connector via an FUSB302 PD controller.
> With measured 15W+ power consumption it should use higher voltage PD modes than
> the standard 5V USB-C mode.
>
> When I add the related connector node in DTS [2] the FUSB302 initializes
> the right PD mode (e.g. 15V/3A).
>
> But during initialisation the PD is switched off shortly and the board has a blackout.
> When I inject a backup supply voltage behind the FUSB302 (e.g. at SYS_12V line) during boot
> I can remove the backup after succesfull setting up the PD and the board will run fine.
>
> Is it possible to change the behaviour of the fusb302 driver to not power down the PD supply
> during init?
I guess it's also possible that the problem is with tcpm.c instead of
fusb302.c. tcpm.c provides the USB PD state matchines. Guenter! Can
you take a look at this?
Both tcpm.c and fusb302.c create debugfs entries that have a more
detailed log about things that are happening. Can you check what you
have in those (when you boot with the mains cable plugged it)?
% mount debugfs -t debugfs /sys/kernel/debug
% cat /sys/kernel/debug/tcpm*
% cat /sys/kernel/debug/fusb302/*
Which kernel are you running by the way?
> In vendor kernel (4.4) this is done somehow but the sources are too different for me to find
> out how.
>
> Gruß,
> --
> Markus Reichl
>
> [1]
> http://download.t-firefly.com/product/RK3399/Docs/Hardware/%E5%8E%9F%E7%90%86%E5%9B%BE%E5%92%8C%E8%B4%B4%E7%89%87%E5%9B%BE/ROC-RK3399-PC/ROC-3399-PC-V10-A-20180804_%E5%8E%9F%E7%90%86%E5%9B%BE.pdf
>
> [2]
> https://lkml.org/lkml/2019/12/10/517
--
heikki
