A USB connector should be a child node of the USB controller
connector/usb-connector.txt. This patch adds a property
"gpio_usb_connector" which declares a connector child device. Code in the
DWC3 driver will then
- Search for "gpio_usb_controller"
- Do an of_platform_populate() if found
This will have the effect of making the declared node a child of the USB
controller and will make sure that USB role-switch events detected with the
gpio_usb_controller driver propagate into the DWC3 controller code
appropriately.
Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
Cc: Rob Herring <robh+dt@xxxxxxxxxx>
Cc: Mark Rutland <mark.rutland@xxxxxxx>
Cc: linux-usb@xxxxxxxxxxxxxxx
Cc: devicetree@xxxxxxxxxxxxxxx
Cc: linux-kernel@xxxxxxxxxxxxxxx
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
---
Documentation/devicetree/bindings/usb/dwc3.txt | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/Documentation/devicetree/bindings/usb/dwc3.txt b/Documentation/devicetree/bindings/usb/dwc3.txt
index 66780a47ad85..b019bd472f83 100644
--- a/Documentation/devicetree/bindings/usb/dwc3.txt
+++ b/Documentation/devicetree/bindings/usb/dwc3.txt
@@ -108,6 +108,9 @@ Optional properties:
When just one value, which means INCRX burst mode enabled. When
more than one value, which means undefined length INCR burst type
enabled. The values can be 1, 4, 8, 16, 32, 64, 128 and 256.
+ - gpio_usb_connector: Declares a USB connector named 'gpio_usb_connector' as a
+ child node of the DWC3 block. Use when modelling a USB
+ connector based on the gpio-usb-b-connector driver.
- in addition all properties from usb-xhci.txt from the current directory are
supported as well
@@ -121,4 +124,12 @@ dwc3@4a030000 {
interrupts = <0 92 4>
usb-phy = <&usb2_phy>, <&usb3,phy>;
snps,incr-burst-type-adjustment = <1>, <4>, <8>, <16>;
+ usb_con: gpio_usb_connector {
+ compatible = "gpio-usb-b-connector";
+ id-gpio = <&tlmm 116 GPIO_ACTIVE_HIGH>;
+ vbus-gpio = <&pms405_gpios 12 GPIO_ACTIVE_HIGH>;
+ vbus-supply = <&usb3_vbus_reg>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb3_id_pin>, <&usb3_vbus_pin>;
+ };
};
--
2.24.0
