Current USB3503 driver ignores GPIO polarity and always operates as if the GPIO lines were flagged as ACTIVE_HIGH. Fix the polarity for the existing USB3503 chip applications to match the chip specification and common convention for naming the pins. The only pin, which has to be ACTIVE_LOW is the reset pin. The remaining are ACTIVE_HIGH. This change allows later to fix the USB3503 driver to properly use generic GPIO bindings and read polarity from DT. Signed-off-by: Marek Szyprowski <m.szyprowski@xxxxxxxxxxx> --- arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts b/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts index fb928503ad45..d9be511f054f 100644 --- a/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts +++ b/arch/arm/boot/dts/sun8i-a83t-cubietruck-plus.dts @@ -101,7 +101,7 @@ initial-mode = <1>; /* initialize in HUB mode */ disabled-ports = <1>; intn-gpios = <&pio 7 5 GPIO_ACTIVE_HIGH>; /* PH5 */ - reset-gpios = <&pio 4 16 GPIO_ACTIVE_HIGH>; /* PE16 */ + reset-gpios = <&pio 4 16 GPIO_ACTIVE_LOW>; /* PE16 */ connect-gpios = <&pio 4 17 GPIO_ACTIVE_HIGH>; /* PE17 */ refclk-frequency = <19200000>; }; -- 2.17.1
