Current USB3503 driver ignores GPIO polarity and always operates as if the GPIO lines were flagged as ACTIVE_HIGH. Fix the polarity for the existing USB3503 chip applications to match the chip specification and common convention for naming the pins. The only pin, which has to be ACTIVE_LOW is the reset pin. The remaining are ACTIVE_HIGH. This change allows later to fix the USB3503 driver to properly use generic GPIO bindings and read polarity from DT. Signed-off-by: Marek Szyprowski <m.szyprowski@xxxxxxxxxxx> --- arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts index 26160c324802..942e3a2cac35 100644 --- a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts +++ b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts @@ -143,7 +143,7 @@ compatible = "smsc,usb3503a"; reg = <0x8>; connect-gpios = <&gpioext2 1 GPIO_ACTIVE_HIGH>; - intn-gpios = <&gpioext2 0 GPIO_ACTIVE_LOW>; + intn-gpios = <&gpioext2 0 GPIO_ACTIVE_HIGH>; initial-mode = <1>; }; }; -- 2.17.1
