On Tue, Sep 24, 2019 at 08:14:00PM +0800, Charles Yeh wrote: > Prolific has developed a new USB to UART chip: PL2303HXN > PL2303HXN : PL2303GC/PL2303GS/PL2303GT/PL2303GL/PL2303GE/PL2303GB > The Vendor request used by the PL2303HXN (TYPE_HXN) is different from > the existing PL2303 series (TYPE_HX & TYPE_01). > Therefore, different Vendor requests are used to issue related commands. > > 1. Added a new TYPE_HXN type in pl2303_type_data, and then executes > new Vendor request,new flow control and other related instructions > if TYPE_HXN is recognized. > > 2. Because the new PL2303HXN only accept the new Vendor request, > the old Vendor request cannot be accepted (the error message > will be returned) > So first determine the TYPE_HX or TYPE_HXN through > PL2303_READ_TYPE_HX_STATUS in pl2303_startup. > > 2.1 If the return message is "1", then the PL2303 is the existing > TYPE_HX/ TYPE_01 series. > The other settings in pl2303_startup are to continue execution. > 2.2 If the return message is "not 1", then the PL2303 is the new > TYPE_HXN series. > The other settings in pl2303_startup are ignored. > (PL2303HXN will directly use the default value in the hardware, > no need to add additional settings through the software) > > 3. In pl2303_open: Because TYPE_HXN is different from the instruction of reset > down/up stream used by TYPE_HX. > Therefore, we will also execute different instructions here. > > 4. In pl2303_set_termios: The UART flow control instructions used by > TYPE_HXN/TYPE_HX/TYPE_01 are different. > Therefore, we will also execute different instructions here. > > 5. In pl2303_vendor_read & pl2303_vendor_write, since TYPE_HXN is different > from the vendor request instruction used by TYPE_HX/TYPE_01, > it will also execute different instructions here. > > 6. In pl2303_update_reg: TYPE_HXN used different register for flow control. > Therefore, we will also execute different instructions here. > > Signed-off-by: Charles Yeh <charlesyeh522@xxxxxxxxx> Now applied, thanks. Johan
