On 24.9.2019 11.35, Peter Chen wrote:
On some situations, the software handles TRB events slower
than adding TRBs, then xhci_handle_event can't return zero
long time, the xHC will consider the event ring is full,
and trigger "Event Ring Full" error, but in fact, the software
has already finished lots of events, just no chance to
update ERDP (event ring dequeue pointer).
In this commit, we force update ERDP if half of TRBS_PER_SEGMENT
events have handled to avoid "Event Ring Full" error.
Signed-off-by: Peter Chen <peter.chen@xxxxxxx>
---
drivers/usb/host/xhci-ring.c | 53 ++++++++++++++++++++++++------------
1 file changed, 36 insertions(+), 17 deletions(-)
diff --git a/drivers/usb/host/xhci-ring.c b/drivers/usb/host/xhci-ring.c
index e220bcbee173..92b6b07cf33d 100644
--- a/drivers/usb/host/xhci-ring.c
+++ b/drivers/usb/host/xhci-ring.c
@@ -2737,6 +2737,35 @@ static int xhci_handle_event(struct xhci_hcd *xhci)
return 1;
}
+/*
+ * Update Event Ring Dequeue Pointer:
+ * - When all events have finished
+ * - To avoid "Event Ring Full Error" condition
+ */
+static void xhci_update_erst_dequeue(struct xhci_hcd *xhci,
+ union xhci_trb *event_ring_deq)
+{
+ u64 temp_64;
+ dma_addr_t deq;
+
+ temp_64 = xhci_read_64(xhci, &xhci->ir_set->erst_dequeue);
+ /* If necessary, update the HW's version of the event ring deq ptr. */
+ if (event_ring_deq != xhci->event_ring->dequeue) {
+ deq = xhci_trb_virt_to_dma(xhci->event_ring->deq_seg,
+ xhci->event_ring->dequeue);
+ if (deq == 0)
+ xhci_warn(xhci, "WARN something wrong with SW event "
+ "ring dequeue ptr.\n");
+ /* Update HC event ring dequeue pointer */
+ temp_64 &= ERST_PTR_MASK;
+ temp_64 |= ((u64) deq & (u64) ~ERST_PTR_MASK);
+ }
+
+ /* Clear the event handler busy flag (RW1C) */
+ temp_64 |= ERST_EHB;
+ xhci_write_64(xhci, temp_64, &xhci->ir_set->erst_dequeue);
+}
+
/*
* xHCI spec says we can get an interrupt, and if the HC has an error condition,
* we might get bad data out of the event ring. Section 4.10.2.7 has a list of
@@ -2748,9 +2777,9 @@ irqreturn_t xhci_irq(struct usb_hcd *hcd)
union xhci_trb *event_ring_deq;
irqreturn_t ret = IRQ_NONE;
unsigned long flags;
- dma_addr_t deq;
u64 temp_64;
u32 status;
+ int event_loop = 0;
spin_lock_irqsave(&xhci->lock, flags);
/* Check if the xHC generated the interrupt, or the irq is shared */
@@ -2804,24 +2833,14 @@ irqreturn_t xhci_irq(struct usb_hcd *hcd)
/* FIXME this should be a delayed service routine
* that clears the EHB.
*/
- while (xhci_handle_event(xhci) > 0) {}
-
- temp_64 = xhci_read_64(xhci, &xhci->ir_set->erst_dequeue);
- /* If necessary, update the HW's version of the event ring deq ptr. */
- if (event_ring_deq != xhci->event_ring->dequeue) {
- deq = xhci_trb_virt_to_dma(xhci->event_ring->deq_seg,
- xhci->event_ring->dequeue);
- if (deq == 0)
- xhci_warn(xhci, "WARN something wrong with SW event "
- "ring dequeue ptr.\n");
- /* Update HC event ring dequeue pointer */
- temp_64 &= ERST_PTR_MASK;
- temp_64 |= ((u64) deq & (u64) ~ERST_PTR_MASK);
+ while (xhci_handle_event(xhci) > 0) {
+ if (event_loop++ < TRBS_PER_SEGMENT / 2)
+ continue;
+ xhci_update_erst_dequeue(xhci, event_ring_deq);
+ event_loop = 0;
}
- /* Clear the event handler busy flag (RW1C); event ring is empty. */
- temp_64 |= ERST_EHB;
- xhci_write_64(xhci, temp_64, &xhci->ir_set->erst_dequeue);
+ xhci_update_erst_dequeue(xhci, event_ring_deq);
Otherwise looks good, but in rare cases when we handle TRBS_PER_SEGMENT/2 events
we might write the ERST twice in a row with the same dequeue value.
xHCI specification section 4.9.4 forbids this:
"Note: Software writes to the ERDP register shall always advance the Event Ring
Dequeue Pointer value, i.e. software shall not write the same value to the ERDP
register on two consecutive write operations."
-Mathias
