We want to configure musb state in omap2430_musb_enable() instead of
omap2430_musb_init(). Otherwise musb may not idle properly until
USB cable has been connected at least once.
And we already have omap_musb_set_mailbox() configure mode with
omap_control_usb_set_mode() so we can remove those calls from
omap2430_musb_enable().
Cc: Jacopo Mondi <jacopo@xxxxxxxxxx>
Cc: Marcel Partap <mpartap@xxxxxxx>
Cc: Merlijn Wajer <merlijn@xxxxxxxxxx>
Cc: Michael Scott <hashcode0f@xxxxxxxxx>
Cc: NeKit <nekit1000@xxxxxxxxx>
Cc: Pavel Machek <pavel@xxxxxx>
Cc: Sebastian Reichel <sre@xxxxxxxxxx>
Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx>
---
drivers/usb/musb/omap2430.c | 20 +++-----------------
1 file changed, 3 insertions(+), 17 deletions(-)
diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/omap2430.c
--- a/drivers/usb/musb/omap2430.c
+++ b/drivers/usb/musb/omap2430.c
@@ -211,7 +211,6 @@ static int omap2430_musb_init(struct musb *musb)
u32 l;
int status = 0;
struct device *dev = musb->controller;
- struct omap2430_glue *glue = dev_get_drvdata(dev->parent);
struct musb_hdrc_platform_data *plat = dev_get_platdata(dev);
struct omap_musb_board_data *data = plat->board_data;
@@ -267,9 +266,6 @@ static int omap2430_musb_init(struct musb *musb)
musb_readl(musb->mregs, OTG_INTERFSEL),
musb_readl(musb->mregs, OTG_SIMENABLE));
- if (glue->status != MUSB_UNKNOWN)
- omap_musb_set_mailbox(glue);
-
return 0;
}
@@ -278,19 +274,9 @@ static void omap2430_musb_enable(struct musb *musb)
struct device *dev = musb->controller;
struct omap2430_glue *glue = dev_get_drvdata(dev->parent);
- switch (glue->status) {
-
- case MUSB_ID_GROUND:
- omap_control_usb_set_mode(glue->control_otghs, USB_MODE_HOST);
- break;
-
- case MUSB_VBUS_VALID:
- omap_control_usb_set_mode(glue->control_otghs, USB_MODE_DEVICE);
- break;
-
- default:
- break;
- }
+ if (glue->status == MUSB_UNKNOWN)
+ glue->status = MUSB_VBUS_OFF;
+ omap_musb_set_mailbox(glue);
}
static void omap2430_musb_disable(struct musb *musb)
--
2.23.0
