On Tue, Aug 27, 2019 at 07:02:07PM +0900, Yoshihiro Shimoda wrote: > If CONFIG_FW_LOADER_USER_HELPER_FALLBACK=y and CONFIG_USB_XHCI_RCAR=y, > request_firmware() in xhci_rcar_download_firmware() waits for 60s to > sysfs fallback for the firmware like below. > > [ 1.599701] xhci-hcd ee000000.usb: xHCI Host Controller > [ 1.604948] xhci-hcd ee000000.usb: new USB bus registered, assigned bus number 3 > [ 1.612403] xhci-hcd ee000000.usb: Direct firmware load for r8a779x_usb3_v3.dlmem failed with error -2 > [ 1.621726] xhci-hcd ee000000.usb: Falling back to sysfs fallback for: r8a779x_usb3_v3.dlmem > [ 1.707953] ata1: link resume succeeded after 1 retries > [ 1.819379] ata1: SATA link down (SStatus 0 SControl 300) > [ 62.436012] xhci-hcd ee000000.usb: can't setup: -11 > [ 62.440901] xhci-hcd ee000000.usb: USB bus 3 deregistered > [ 62.446361] xhci-hcd: probe of ee000000.usb failed with error -11 > > To avoid this 60s wait, this patch adds to check the system_state > condition and if the system is not running, > xhci_rcar_download_firmware() calls request_firmware_direct() > instead of request_firmware() as a workaround. > > Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> It seems to me that request_firmware() is working as expected. And that this patch introduces an alternate behaviour for xhci-rcar where it will fall back to the user-space helper in some cases but not others. This inconsistency isn't obviously correct to me. Perhaps xhci-rcar should always call request_firmware_direct() ? > --- > drivers/usb/host/xhci-rcar.c | 6 +++++- > 1 file changed, 5 insertions(+), 1 deletion(-) > > diff --git a/drivers/usb/host/xhci-rcar.c b/drivers/usb/host/xhci-rcar.c > index 34761be..c90cf46 100644 > --- a/drivers/usb/host/xhci-rcar.c > +++ b/drivers/usb/host/xhci-rcar.c > @@ -6,6 +6,7 @@ > */ > > #include <linux/firmware.h> > +#include <linux/kernel.h> > #include <linux/module.h> > #include <linux/platform_device.h> > #include <linux/of.h> > @@ -146,7 +147,10 @@ static int xhci_rcar_download_firmware(struct usb_hcd *hcd) > firmware_name = priv->firmware_name; > > /* request R-Car USB3.0 firmware */ > - retval = request_firmware(&fw, firmware_name, dev); > + if (system_state < SYSTEM_RUNNING) > + retval = request_firmware_direct(&fw, firmware_name, dev); > + else > + retval = request_firmware(&fw, firmware_name, dev); > if (retval) > return retval; > > -- > 2.7.4 >
