On Wed, Jul 24, 2019 at 03:27:51PM +0200, Maik Stohn wrote: > KERNEL CRASH when using XHCI devices (affects any architecture, any USB device) > > This was already reported as a kernel bug in bugzilla (https://bugzilla.kernel.org/show_bug.cgi?id=204257) but I got told to report it here since it is usb related... > > Affected kernels: 5.2, 5.2.1, 5.2.2, 5.3-rc1, ... > > This bug is already causing real world problems with existing software and devices using SCSI BOT with raw SCSI commands and libusb software. > > Reproduce (tested on several different machines with 5.2,5.2.1,5.2.2,5.3rc1): > > - usb flash drive attached to XHCI controller (e.g. USB3.0 flash drive attached to USB3.0 port) > - generic scsi module loaded (e.g. /dev/sg0 comes up when attaching the flash drive) > - command line tool "sg_raw" from "sg3-utils" > - execute: and press a key + return (-s1 sends one byte which is read from stdin) > $ sudo sg_raw -s1 /dev/sg0 00 00 00 00 00 00 00 00 00 00 > > -> KERNEL Oops > > - same for -s2, -s3, ... up to -s8 (sending 1 to 8 bytes, exactly the maximum of bytes on my 64 bit machine where the "DMA bypass optimization / IDT" kicks in, see below) > > Since this can be triggered by any normal user (without any special USB device needed) I think it is important enough to fix it for the existing 5.2 kernel as well. > > --- > > Patch introducing the crash: https://patchwork.kernel.org/patch/10919167 / commit 33e39350ebd20fe6a77a51b8c21c3aa6b4a208cf - "usb: xhci: add Immediate Data Transfer support" > > Reason: NULL pointer dereference > > --- > > I took me quite some time to find the cause of this. > > I narrowed the crash down to the place inside of "xhci_queue_bulk_tx" in "xhci-ring.c" where the next SG is loaded > > ... > while (sg && sent_len >= block_len) { > /* New sg entry */ > --num_sgs; > sent_len -= block_len; > if (num_sgs != 0) { > sg = sg_next(sg); > block_len = sg_dma_len(sg); <================= CRASH > The comment of "sg_dma_len" clearly states "These macros should be used after a dma_map_sg call has been done..." - which was > omitted by the new "xhci_map_urb_for_dma" function since the transfer was considered suitable for IDT. > addr = (u64) sg_dma_address(sg); > addr += sent_len; > } > } > block_len -= sent_len; > send_addr = addr; > ... > > This only happens if the transfer was cosnideres suitable for IDT. > When I patched the function "xhci_urb_suitable_for_idt" to always return false (nothing suitable for IDT) everything was working fine. > > > Unfortunately I'm not deep enough into the inner workings of the kernel usb host driver to find a solution for this other than reverting the patch for IDT. What patch did you find that caused this regression? We can revert it if that is the easiest thing to do. thanks, greg k-h
