Added the newly added limit and updated the text a bit Signed-off-by: Oliver Neukum <oneukum@xxxxxxxx> --- Documentation/usb/rio.txt | 54 +++++++++++++---------------------------------- 1 file changed, 15 insertions(+), 39 deletions(-) diff --git a/Documentation/usb/rio.txt b/Documentation/usb/rio.txt index ca9adcf56355..63adb030e0e9 100644 --- a/Documentation/usb/rio.txt +++ b/Documentation/usb/rio.txt @@ -76,54 +76,25 @@ Additional Information and userspace tools Requirements ============ -A host with a USB port. Ideally, either a UHCI (Intel) or OHCI -(Compaq and others) hardware port should work. +A host with a USB port running a Linux kernel with RIO 500 support enabled. -A Linux development kernel (2.3.x) with USB support enabled or a -backported version to linux-2.2.x. See http://www.linux-usb.org for -more information on accomplishing this. +The driver is a module called rio500, which should be automatically loaded +as you plug in your device. +If that fails you can manually load it with -A Linux kernel with RIO 500 support enabled. + modprobe rio500 -'lspci' which is only needed to determine the type of USB hardware -available in your machine. - -Configuration - -Using `lspci -v`, determine the type of USB hardware available. - - If you see something like:: - - USB Controller: ...... - Flags: ..... - I/O ports at .... - - Then you have a UHCI based controller. - - If you see something like:: - - USB Controller: ..... - Flags: .... - Memory at ..... - - Then you have a OHCI based controller. - -Using `make menuconfig` or your preferred method for configuring the -kernel, select 'Support for USB', 'OHCI/UHCI' depending on your -hardware (determined from the steps above), 'USB Diamond Rio500 support', and -'Preliminary USB device filesystem'. Compile and install the modules -(you may need to execute `depmod -a` to update the module -dependencies). - -Add a device for the USB rio500:: +Udev should automatically create a device node as soon as plug in your device. +If that fails, you can manually add a device for the USB rio500:: mknod /dev/usb/rio500 c 180 64 -Set appropriate permissions for /dev/usb/rio500 (don't forget about +In that case, +set appropriate permissions for /dev/usb/rio500 (don't forget about group and world permissions). Both read and write permissions are required for proper operation. -Load the appropriate modules (if compiled as modules): +Load the appropriate modules (if ddcompiled as modules): OHCI:: @@ -140,6 +111,11 @@ Load the appropriate modules (if compiled as modules): That's it. The Rio500 Utils at: http://rio500.sourceforge.net should be able to access the rio500. +Limits +====== + +You can use only a single rio500 device at a time with your computer. + Bugs ==== -- 2.16.4
