On Tue, 16 Apr 2019, syzbot wrote: > Hello, > > syzbot has tested the proposed patch but the reproducer still triggered > crash: > INFO: task hung in usb_kill_urb That's surprising. This patch was awfully similar to the previous one, which did prevent the crash earlier. > Tested on: > > commit: 9a33b369 usb-fuzzer: main usb gadget fuzzer driver > git tree: https://github.com/google/kasan/tree/usb-fuzzer > console output: https://syzkaller.appspot.com/x/log.txt?x=10b5e057200000 > kernel config: https://syzkaller.appspot.com/x/.config?x=23e37f59d94ddd15 > compiler: gcc (GCC) 9.0.0 20181231 (experimental) > patch: https://syzkaller.appspot.com/x/patch.diff?x=131dca6b200000 Andrey, is there any way to increase the console output buffer size? The link above doesn't go all the way back to the beginning of the test (it starts at timestamp 486.614697). Also, here's a slightly revised patch for testing. Alan Stern #syz test: https://github.com/google/kasan.git usb-fuzzer --- a/drivers/usb/gadget/udc/dummy_hcd.c +++ b/drivers/usb/gadget/udc/dummy_hcd.c @@ -979,8 +979,18 @@ static int dummy_udc_start(struct usb_ga struct dummy_hcd *dum_hcd = gadget_to_dummy_hcd(g); struct dummy *dum = dum_hcd->dum; - if (driver->max_speed == USB_SPEED_UNKNOWN) + switch (g->speed) { + /* All the speeds we support */ + case USB_SPEED_LOW: + case USB_SPEED_FULL: + case USB_SPEED_HIGH: + case USB_SPEED_SUPER: + break; + default: + dev_err(dummy_dev(dum_hcd), "Unsupported driver max speed %d\n", + driver->max_speed); return -EINVAL; + } /* * SLAVE side init ... the layer above hardware, which @@ -1784,9 +1794,10 @@ static void dummy_timer(struct timer_lis /* Bus speed is 500000 bytes/ms, so use a little less */ total = 490000; break; - default: + default: /* Can't happen */ dev_err(dummy_dev(dum_hcd), "bogus device speed\n"); - return; + total = 0; + break; } /* FIXME if HZ != 1000 this will probably misbehave ... */ @@ -1828,7 +1839,7 @@ restart: /* Used up this frame's bandwidth? */ if (total <= 0) - break; + continue; /* find the gadget's ep for this request (if configured) */ address = usb_pipeendpoint (urb->pipe);
