On Thu, Feb 14, 2019 at 12:08 AM Pawel Laszczak <pawell@xxxxxxxxxxx> wrote:
>
> Hi Rob,
> >On Thu, Jan 31, 2019 at 11:52:28AM +0000, Pawel Laszczak wrote:
> >> This patch aim at documenting USB related dt-bindings for the
> >> Cadence USBSS-DRD controller.
> >>
> >> Signed-off-by: Pawel Laszczak <pawell@xxxxxxxxxxx>
> >> ---
> >> .../devicetree/bindings/usb/cdns-usb3.txt | 33 +++++++++++++++++++
> >> 1 file changed, 33 insertions(+)
> >> create mode 100644 Documentation/devicetree/bindings/usb/cdns-usb3.txt
> >>
> >> diff --git a/Documentation/devicetree/bindings/usb/cdns-usb3.txt b/Documentation/devicetree/bindings/usb/cdns-usb3.txt
> >> new file mode 100644
> >> index 000000000000..6dc38be77f5c
> >> --- /dev/null
> >> +++ b/Documentation/devicetree/bindings/usb/cdns-usb3.txt
> >> @@ -0,0 +1,33 @@
> >> +Binding for the Cadence USBSS-DRD controller
> >> +
> >> +Required properties:
> >> + - reg: Physical base address and size of the controller's register areas.
> >> + Controller has 3 different regions:
> >> + region 1 - HOST registers area
> >> + region 2 - DEVICE registers area
> >> + region 3 - OTG/DRD registers area
> >> + - reg-names - register memory area names:
> >> + "xhci" - for HOST registers space
> >> + "dev" - for DEVICE registers space
> >> + "otg" - for OTG/DRD registers space
> >> + - compatible: Should contain: "cdns,usb3-1.0.0" or "cdns,usb3-1.0.1"
> >> + - interrupts: Interrupt specifier. Refer to interrupt bindings.
> >> + Driver supports only single interrupt line.
> >
> >Driver supports or h/w only has 1 interrupt?
>
> h/w internally has 3 separate interrupt line, but in my testing board
> they are ored. So physically driver sees only one h/w interrupt line and
> assumes that h/w has single common interrupt line.
If it is possible for others to have 3 separate lines then you should
have 3. Just repeat the connection 3 times. Or the binding can support
1 or 3 interrupts based on the h/w. Either way it's not about what the
driver supports, but what the h/w looks like.
> >> + This single interrupt is shared between Device,
> >> + host and OTG/DRD part of driver.
> >> +
> >> +Optional properties:
> >> + - maximum-speed : valid arguments are "super-speed", "high-speed" and
> >> + "full-speed"; refer to usb/generic.txt
> >> + - dr_mode: Should be one of "host", "peripheral" or "otg".
> >> + - phys: reference to the USB PHY
> >> +
> >> +Example:
> >> + usb@f3000000 {
> >> + compatible = "cdns,usb3";
> >
> >Doesn't match above.
> Right, should be:
> Compatible = " cdns,usb3-1.0.0", "cdns,usb3-1.0.1";
No, that doesn't match either. Above you said "or".
Rob
