Hi Thierry, On 04-02-2019 17:16, Thierry Reding wrote: > On Thu, Jan 03, 2019 at 03:34:51PM +0530, Nagarjuna Kristam wrote: >> Add driver for XUSB device mode controller available on Tegra >> Soc >> >> Patches 1-3 are phy driver changes to add support for device >> mode Patches 4-7 are changes related to XUSB device mode >> controller driver Patch 8 is to enable XUDC driver in defconfig >> >> Test Steps(USB 2.0): >> - Enable "USB Gadget precomposed configurations" in defconfig >> - Build, flash and boot Jetson TX1 >> - Connect Jetson TX1 and Ubuntu device using USB A to Micro B >> cable >> - After boot on Jetson TX1 terminal usb0 network device should be >> enumerated >> - Assign static ip to usb0 on Jetson TX1 and corresponding net >> device on ubuntu >> - Run ping test and transfer test(used scp) to check data transfer >> communication >> >> SS mode is verified by enabling Type A port as device >> >> Above patches are dependent on >> https://patchwork.ozlabs.org/patch/976332/ >> >> Nagarjuna Kristam (8): >> phy: tegra: xusb: t210: add XUSB device mode support >> arm64: tegra: Add nvidia,usb3-port-fake entry to Jetson TX1 padctl >> dt-bindings: phy: tegra-xusb-padctl: Add nvidia,usb3-port-fake entry > > Nit: it's usually best to send out the DT bindings changes before the > driver or DT changes. That way reviewers can review in the natural order > rather than find out after going through the implementation what the DT > bindings intended. > Will re-arrange if a new patch series is created, as re-arrange causes current series of patches as new series > Thierry > - Nagarjuna
