The ax88772_bind() should return error code immediately when the PHY
was not reset properly through ax88772a_hw_reset().
Otherwise, The asix_get_phyid() will block when get the PHY
Identifier from the PHYSID1 MII registers through asix_mdio_read()
due to the PHY isn't ready. Furthermore, it will produce a lot of
error message cause system crash.As follows:
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to write
reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to send
software reset: ffffffb9
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to write
reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to enable
software MII access
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to read
reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to write
reg index 0x0000: -71
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to enable
software MII access
asix 1-1:1.0 (unnamed net_device) (uninitialized): Failed to read
reg index 0x0000: -71
...
Signed-off-by: Zhang Run <zhang.run@xxxxxxxxxx>
Reviewed-by: Yang Wei <yang.wei9@xxxxxxxxxx>
---
drivers/net/usb/asix_devices.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)
diff --git a/drivers/net/usb/asix_devices.c b/drivers/net/usb/asix_devices.c
index b654f05..3d93993 100644
--- a/drivers/net/usb/asix_devices.c
+++ b/drivers/net/usb/asix_devices.c
@@ -739,8 +739,13 @@ static int ax88772_bind(struct usbnet *dev, struct usb_interface *intf)
asix_read_cmd(dev, AX_CMD_STATMNGSTS_REG, 0, 0, 1, &chipcode, 0);
chipcode &= AX_CHIPCODE_MASK;
- (chipcode == AX_AX88772_CHIPCODE) ? ax88772_hw_reset(dev, 0) :
- ax88772a_hw_reset(dev, 0);
+ ret = (chipcode == AX_AX88772_CHIPCODE) ? ax88772_hw_reset(dev, 0) :
+ ax88772a_hw_reset(dev, 0);
+
+ if (ret < 0) {
+ netdev_dbg(dev->net, "Failed to reset AX88772: %d\n", ret);
+ return ret;
+ }
/* Read PHYID register *AFTER* the PHY was reset properly */
phyid = asix_get_phyid(dev);
--
2.7.4
