The i.MX USB controller may drive the usb power line directly, but the polarity depends on the board. Reset state of the polarity is low-active so add this property to allow it to be high-active. Signed-off-by: Philipp Puschmann <philipp.puschmann@xxxxxxxxx> Reviewed-by: Rob Herring <robh@xxxxxxxxxx> --- Changes in v4: do not limit to i.MX6 Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 1 + 1 file changed, 1 insertion(+) diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt index adae82385dd6..a254386a91ad 100644 --- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt +++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt @@ -93,6 +93,7 @@ i.mx specific properties - over-current-active-low: over current signal polarity is active low. - over-current-active-high: over current signal polarity is active high. It's recommended to specify the over current polarity. +- power-active-high: power signal polarity is active high - external-vbus-divider: enables off-chip resistor divider for Vbus Example: -- 2.20.1
