The i.MX6q/dl USB controller may drive the usb power line directly, but the polarity depends on the board. Reset state of the polarity is low-active so add this property to allow it to be high-active. Signed-off-by: Philipp Puschmann <philipp.puschmann@xxxxxxxxx> --- Changes in v3: add description --- Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 1 + 1 file changed, 1 insertion(+) diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt index adae82385dd6..8696e3eff6e7 100644 --- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt +++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt @@ -93,6 +93,7 @@ i.mx specific properties - over-current-active-low: over current signal polarity is active low. - over-current-active-high: over current signal polarity is active high. It's recommended to specify the over current polarity. +- power-active-high: power signal polarity is high active (only for imx6q/dl) - external-vbus-divider: enables off-chip resistor divider for Vbus Example: -- 2.20.1
