Currently the code will set US_FL_SANE_SENSE flag unconditionally if device claims SPC3+, however we should allow US_FL_BAD_SENSE flag to prevent this behavior, because SMI SM3350 UFS-USB bridge controller, which claims SPC4, will show strange behavior with 96-byte sense (put the chip into a wrong state that cannot read/write anything). Check the presence of US_FL_BAD_SENSE when assuming US_FL_SANE_SENSE on SPC4+ devices. Signed-off-by: Icenowy Zheng <icenowy@xxxxxxx> --- Changes in v2: - Changed the comment to note the check. drivers/usb/storage/scsiglue.c | 8 ++++++-- 1 file changed, 6 insertions(+), 2 deletions(-) diff --git a/drivers/usb/storage/scsiglue.c b/drivers/usb/storage/scsiglue.c index fde2e71a6ade..a73ea495d5a7 100644 --- a/drivers/usb/storage/scsiglue.c +++ b/drivers/usb/storage/scsiglue.c @@ -235,8 +235,12 @@ static int slave_configure(struct scsi_device *sdev) if (!(us->fflags & US_FL_NEEDS_CAP16)) sdev->try_rc_10_first = 1; - /* assume SPC3 or latter devices support sense size > 18 */ - if (sdev->scsi_level > SCSI_SPC_2) + /* + * assume SPC3 or latter devices support sense size > 18 + * unless US_FL_BAD_SENSE quirk is specified. + */ + if (sdev->scsi_level > SCSI_SPC_2 && + !(us->fflags & US_FL_BAD_SENSE)) us->fflags |= US_FL_SANE_SENSE; /* -- 2.18.1
