[PATCH v3 3/3] usb: chipidea: imx: allow to configure oc polarity on i.MX25

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Up to now the polarity of the over current pin was hard coded to active
high. Use the already defined device tree properties to configure polarity
on i.MX25, too. In difference to i.MX6/7 use active high behavior if the
polarity is unspecified to keep compatibility to existing device trees.

Signed-off-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>
---
 drivers/usb/chipidea/usbmisc_imx.c | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/drivers/usb/chipidea/usbmisc_imx.c b/drivers/usb/chipidea/usbmisc_imx.c
index 4a8de1b37f67..47eee5cade84 100644
--- a/drivers/usb/chipidea/usbmisc_imx.c
+++ b/drivers/usb/chipidea/usbmisc_imx.c
@@ -120,6 +120,14 @@ static int usbmisc_imx25_init(struct imx_usbmisc_data *data)
 		val &= ~(MX25_OTG_SIC_MASK | MX25_OTG_PP_BIT);
 		val |= (MX25_EHCI_INTERFACE_DIFF_UNI & MX25_EHCI_INTERFACE_MASK) << MX25_OTG_SIC_SHIFT;
 		val |= (MX25_OTG_PM_BIT | MX25_OTG_OCPOL_BIT);
+
+		/*
+		 * If the polarity is not configured assume active high for
+		 * historical reasons.
+		 */
+		if (data->oc_pol_configured && data->oc_pol_active_low)
+			val &= ~MX25_OTG_OCPOL_BIT;
+
 		writel(val, usbmisc->base);
 		break;
 	case 1:
@@ -129,6 +137,13 @@ static int usbmisc_imx25_init(struct imx_usbmisc_data *data)
 		val |= (MX25_H1_PM_BIT | MX25_H1_OCPOL_BIT | MX25_H1_TLL_BIT |
 			MX25_H1_USBTE_BIT | MX25_H1_IPPUE_DOWN_BIT);
 
+		/*
+		 * If the polarity is not configured assume active high for
+		 * historical reasons.
+		 */
+		if (data->oc_pol_configured && data->oc_pol_active_low)
+			val &= ~MX25_H1_OCPOL_BIT;
+
 		writel(val, usbmisc->base);
 
 		break;
-- 
2.19.2




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux