Re: [PATCH v3] xhci: workaround CSS timeout on AMD SNPS 3.0 xHC

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




> On Nov 24, 2018, at 00:24, Singh, Sandeep <sandeep.singh@xxxxxxx> wrote:
> 
> From: Sandeep Singh <sandeep.singh@xxxxxxx>
> 
> Occasionally AMD SNPS 3.0 xHC does not respond to
> CSS when set, also it does not flag anything on SRE and HCE
> to point the internal xHC errors on USBSTS register. This stalls
> the entire system wide suspend and there is no point in stalling
> just because of xHC CSS is not responding.
> 
> To work around this problem, if the xHC does not flag
> anything on SRE and HCE, we can skip the CSS
> timeout and allow the system to continue the suspend. Once the
> system resume happens we can internally reset the controller
> using XHCI_RESET_ON_RESUME quirk
> 
> Signed-off-by: Shyam Sundar S K <Shyam-sundar.S-k@xxxxxxx>
> Signed-off-by: Sandeep Singh <Sandeep.Singh@xxxxxxx>
> cc: Nehal Shah <Nehal-bakulchandra.Shah@xxxxxxx>

Tested-by: Kai-Heng Feng <kai.heng.feng@xxxxxxxxxxxxx>

> ---
> Changes since v1:
> 
> -> New Variable based decision making when SNPS issue happens hence 
> -> quirk interdependency removed.
> -> Removed STS conditional check in suspend function.
> 
> Changes since v2:
> -> Updated quirk bit as per Kai-heng comment.
> 
> drivers/usb/host/xhci-pci.c |  4 ++++
> drivers/usb/host/xhci.c     | 26 ++++++++++++++++++++++----
> drivers/usb/host/xhci.h     |  3 +++
> 3 files changed, 29 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
> index a951526..a9ec705 100644
> --- a/drivers/usb/host/xhci-pci.c
> +++ b/drivers/usb/host/xhci-pci.c
> @@ -139,6 +139,10 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
> 		 pdev->device == 0x43bb))
> 		xhci->quirks |= XHCI_SUSPEND_DELAY;
> 
> +	if (pdev->vendor == PCI_VENDOR_ID_AMD &&
> +	    (pdev->device == 0x15e0 || pdev->device == 0x15e1))
> +		xhci->quirks |= XHCI_SNPS_BROKEN_SUSPEND;
> +
> 	if (pdev->vendor == PCI_VENDOR_ID_AMD)
> 		xhci->quirks |= XHCI_TRUST_TX_LENGTH;
> 
> diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
> index c928dbb..c20b85e 100644
> --- a/drivers/usb/host/xhci.c
> +++ b/drivers/usb/host/xhci.c
> @@ -968,6 +968,7 @@ int xhci_suspend(struct xhci_hcd *xhci, bool do_wakeup)
> 	unsigned int		delay = XHCI_MAX_HALT_USEC;
> 	struct usb_hcd		*hcd = xhci_to_hcd(xhci);
> 	u32			command;
> +	u32			res;
> 
> 	if (!hcd->state)
> 		return 0;
> @@ -1021,11 +1022,28 @@ int xhci_suspend(struct xhci_hcd *xhci, bool do_wakeup)
> 	command = readl(&xhci->op_regs->command);
> 	command |= CMD_CSS;
> 	writel(command, &xhci->op_regs->command);
> +	xhci->broken_suspend = 0;
> 	if (xhci_handshake(&xhci->op_regs->status,
> 				STS_SAVE, 0, 10 * 1000)) {
> -		xhci_warn(xhci, "WARN: xHC save state timeout\n");
> -		spin_unlock_irq(&xhci->lock);
> -		return -ETIMEDOUT;
> +	/*
> +	 * AMD SNPS xHC 3.0 occasionally does not clear the
> +	 * SSS bit of USBSTS and when driver tries to poll
> +	 * to see if the xHC clears BIT(8) which never happens
> +	 * and driver assumes that controller is not responding
> +	 * and times out. To workaround this, its good to check
> +	 * if SRE and HCE bits are not set (as per xhci
> +	 * Section 5.4.2) and bypass the timeout.
> +	 */
> +		res = readl(&xhci->op_regs->status);
> +		if ((xhci->quirks & XHCI_SNPS_BROKEN_SUSPEND) &&
> +		    (((res & STS_SRE) == 0) &&
> +				((res & STS_HCE) == 0))) {
> +			xhci->broken_suspend = 1;
> +		} else {
> +			xhci_warn(xhci, "WARN: xHC save state timeout\n");
> +			spin_unlock_irq(&xhci->lock);
> +			return -ETIMEDOUT;
> +		}
> 	}
> 	spin_unlock_irq(&xhci->lock);
> 
> @@ -1078,7 +1096,7 @@ int xhci_resume(struct xhci_hcd *xhci, bool hibernated)
> 	set_bit(HCD_FLAG_HW_ACCESSIBLE, &xhci->shared_hcd->flags);
> 
> 	spin_lock_irq(&xhci->lock);
> -	if (xhci->quirks & XHCI_RESET_ON_RESUME)
> +	if ((xhci->quirks & XHCI_RESET_ON_RESUME) || xhci->broken_suspend)
> 		hibernated = true;
> 
> 	if (!hibernated) {
> diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
> index 260b259..c3515ba 100644
> --- a/drivers/usb/host/xhci.h
> +++ b/drivers/usb/host/xhci.h
> @@ -1850,6 +1850,7 @@ struct xhci_hcd {
> #define XHCI_ZERO_64B_REGS	BIT_ULL(32)
> #define XHCI_DEFAULT_PM_RUNTIME_ALLOW	BIT_ULL(33)
> #define XHCI_RESET_PLL_ON_DISCONNECT	BIT_ULL(34)
> +#define XHCI_SNPS_BROKEN_SUSPEND    BIT_ULL(35)
> 
> 	unsigned int		num_active_eps;
> 	unsigned int		limit_active_eps;
> @@ -1879,6 +1880,8 @@ struct xhci_hcd {
> 	void			*dbc;
> 	/* platform-specific data -- must come last */
> 	unsigned long		priv[0] __aligned(sizeof(s64));
> +	/* Broken Suspend flag for SNPS Suspend resume issue */
> +	u8			broken_suspend;
> };
> 
> /* Platform specific overrides to generic XHCI hc_driver ops */
> -- 
> 2.7.4
> 




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux