Realtek USB3.0 Card Reader [0bda:0328] reports wrong port status on
Cannon lake PCH USB3.1 xHCI [8086:a36d] after resume from S3,
after clear port reset it works fine.
Since this device is registered on USB3 roothub at boot,
when port status reports not superspeed, xhci_get_port_status will call
an uninitialized completion in bus_state[0].
Kernel will hang because of NULL pointer.
Restrict the USB2 resume status check in USB2 roothub to fix hang issue.
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Aaron Ma <aaron.ma@xxxxxxxxxxxxx>
---
drivers/usb/host/xhci-hub.c | 2 +-
drivers/usb/host/xhci-ring.c | 2 +-
2 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/host/xhci-hub.c b/drivers/usb/host/xhci-hub.c
index 7e2a531ba321..56a08daa7431 100644
--- a/drivers/usb/host/xhci-hub.c
+++ b/drivers/usb/host/xhci-hub.c
@@ -876,7 +876,7 @@ static u32 xhci_get_port_status(struct usb_hcd *hcd,
status |= USB_PORT_STAT_SUSPEND;
}
if ((raw_port_status & PORT_PLS_MASK) == XDEV_RESUME &&
- !DEV_SUPERSPEED_ANY(raw_port_status)) {
+ !DEV_SUPERSPEED_ANY(raw_port_status) && hcd->speed < HCD_USB3) {
if ((raw_port_status & PORT_RESET) ||
!(raw_port_status & PORT_PE))
return 0xffffffff;
diff --git a/drivers/usb/host/xhci-ring.c b/drivers/usb/host/xhci-ring.c
index f0a99aa0ac58..7318fc422b6c 100644
--- a/drivers/usb/host/xhci-ring.c
+++ b/drivers/usb/host/xhci-ring.c
@@ -1634,7 +1634,7 @@ static void handle_port_status(struct xhci_hcd *xhci,
* RExit to a disconnect state). If so, let the the driver know it's
* out of the RExit state.
*/
- if (!DEV_SUPERSPEED_ANY(portsc) &&
+ if (!DEV_SUPERSPEED_ANY(portsc) && hcd->speed < HCD_USB3 &&
test_and_clear_bit(hcd_portnum,
&bus_state->rexit_ports)) {
complete(&bus_state->rexit_done[hcd_portnum]);
--
2.19.1
