>From USB_PD_R3_0 7.1.5 Response to Hard Resets Device operation during and after a Hard Reset is defined as follows: Self-powered devices Should Not disconnect from USB during a Hard Reset (see Section 9.1.2). Bus powered devices will disconnect from USB during a Hard Reset due to the loss of their power source. Therefore it is necessary to know whether the port belongs to a device which is self powered or bus powered. This change adds "self-powered" flag to the connector class which present indicates that the port belongs to a device that is self powered. Else it is bus powered usb device. Signed-off-by: Badhri Jagan Sridharan <badhri@xxxxxxxxxx> ------- Changes is v3: - Rebase on top of usb-next - no change w.r.t to this patch. Same as previous versions. No v2 version as the patch was introduced there. --- Documentation/devicetree/bindings/connector/usb-connector.txt | 2 ++ 1 file changed, 2 insertions(+) diff --git a/Documentation/devicetree/bindings/connector/usb-connector.txt b/Documentation/devicetree/bindings/connector/usb-connector.txt index d90e17e2428b..a9a2f2fc44f2 100644 --- a/Documentation/devicetree/bindings/connector/usb-connector.txt +++ b/Documentation/devicetree/bindings/connector/usb-connector.txt @@ -14,6 +14,8 @@ Optional properties: - label: symbolic name for the connector, - type: size of the connector, should be specified in case of USB-A, USB-B non-fullsize connectors: "mini", "micro". +- self-powered: Set this property if the usb device that has its own power + source. Optional properties for usb-c-connector: - power-role: should be one of "source", "sink" or "dual"(DRP) if typec -- 2.19.0.605.g01d371f741-goog
