Hi,
I got a report saying that when overcurrent happens in one of the hub
downstream ports, USB_PORT_STAT_OVERCURRENT is not set in portstatus,
instead USB_PORT_STAT_C_OVERCURRENT is set in portchange, then the
overcurrent condition is not handled in hub_event().
The following patch solves the issue.
t a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index 442be7f312f6..118557acc74b 100644
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -1144,7 +1144,8 @@ static void hub_activate(struct usb_hub *hub, enum hub_activation_type type)
* check for a new connection
*/
if (udev || (portstatus & USB_PORT_STAT_CONNECTION) ||
- (portstatus & USB_PORT_STAT_OVERCURRENT))
+ (portstatus & USB_PORT_STAT_OVERCURRENT) ||
+ (portchange & USB_PORT_STAT_C_OVERCURRENT))
set_bit(port1, hub->change_bits);
} else if (portstatus & USB_PORT_STAT_ENABLE) {
The usb2.0 spec section 11.12.5 states
"If a hub has per-port power switching and per-port current limiting, an
over-current on one port may still cause the power on another port to
fall below specific minimums. In this case, the affected port is placed
in the Power-Off state and C_PORT_OVER_CURRENT is set for the port, but
PORT_OVER_CURRENT is not set."
So is the patch above a proper fix? or something else might be missing?
Thanks,
-Bin.
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
