Hi, this is from another e-mail account, where I now subscribed to this list. Don't know, if this will be of any help. git checkout v4.16 git revert --strategy-option=ours 0e1f0ea -n git cherry-pick 854e55ad289ef8888e7991f0ada5846f5afb9 -n git cherry-pick ad343a98e74e85aa91d844310e797f96fee6983b -n First boot with this kernel, and that Renesas card, did not show up the attached devices. Power off, remove power cable, remove battery, push power button to switch on, card was removed. After that, reconnect all, put the USB3 card into the slot. Boot up. No device recognized. Remove card, reinsert card. device shows. SMART Values are not shown anymore, even on the USB 2.0 ports. I got to use that laptop, don't boot it so often. part from dmesg [ 0.000000] Linux version 4.16.0-ARCH-renesas+ (user@xxxxxxxxxxxxxxxxxxxx) (gcc version 8.1.0 (GCC)) #2 SMP PREEMPT Wed May 30 20:26:31 CEST 2018 [ 0.000000] Command line: BOOT_IMAGE=/boot/vmlinuz-linux4.16.0-ARCH-renesas+ "acpi_osi=!Windows 2012" root=/dev/sda12 zswap.enabled=1 zswap.compressor=lz4 rw acpi_osi=Linux threadirqs pcie_aspm=force i915.i915_enable_rc6=1 i915.i915_enable_fbc=1 i915.lvds_downclock=1 drm.debug=0xe intel_iommu=igfx_off intel_iommu=soft pciehp.pciehp_force=1 verbose debug [ 72.915304] xhci_hcd 0000:05:00.0: xHCI Host Controller [ 72.915311] xhci_hcd 0000:05:00.0: new USB bus registered, assigned bus number 3 [ 72.920586] xhci_hcd 0000:05:00.0: hcc params 0x014051cf hci version 0x100 quirks 0x00000090 [ 72.921124] hub 3-0:1.0: USB hub found [ 72.922088] hub 3-0:1.0: 2 ports detected [ 72.922680] xhci_hcd 0000:05:00.0: xHCI Host Controller [ 72.922684] xhci_hcd 0000:05:00.0: new USB bus registered, assigned bus number 4 [ 72.924101] usb usb4: We don't know the algorithms for LPM for this host, disabling LPM. [ 72.925733] hub 4-0:1.0: USB hub found [ 72.925744] hub 4-0:1.0: 2 ports detected [ 73.250020] usb 3-1: new high-speed USB device number 2 using xhci_hcd [ 74.273885] usb 4-2: new SuperSpeed USB device number 2 using xhci_hcd [ 74.870888] usb-storage 3-1:1.0: USB Mass Storage device detected [ 74.871678] scsi host4: usb-storage 3-1:1.0 [ 74.872320] usbcore: registered new interface driver usb-storage [ 74.879429] scsi host5: uas [ 74.880120] usbcore: registered new interface driver uas [ 74.881221] scsi 5:0:0:0: Direct-Access Seagate M3 Portable 9300 PQ: 0 ANSI: 6 [ 74.882418] sd 5:0:0:0: Attached scsi generic sg2 type 0 [ 74.882765] sd 5:0:0:0: [sdc] 7814037167 512-byte logical blocks: (4.00 TB/3.64 TiB) ... [ 75.168568] sd 5:0:0:0: [sdc] Write Protect is off [ 75.171102] sd 5:0:0:0: [sdc] Mode Sense: 4f 00 00 00 [ 75.173896] sd 5:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA [ 75.176015] xhci_hcd 0000:05:00.0: ERROR Transfer event for unknown stream ring slot 3 ep 2 [ 75.177172] xhci_hcd 0000:05:00.0: @00000003f4f055f0 00000000 00000000 1b000000 03038001 [ 75.538169] systemd-journald[286]: Successfully sent stream file descriptor to service manager. [ 75.540504] systemd-journald[286]: Successfully sent stream file descriptor to service manager. [ 75.566508] systemd-journald[286]: Successfully sent stream file descriptor to service manager. [ 75.574355] systemd-journald[286]: Successfully sent stream file descriptor to service manager. [ 75.575969] systemd-journald[286]: Successfully sent stream file descriptor to service manager. [ 75.577960] systemd-journald[286]: Successfully sent stream file descriptor to service manager. [ 75.581890] systemd-journald[286]: Successfully sent stream file descriptor to service manager. [ 75.894654] scsi 4:0:0:0: Direct-Access SanDisk Ultra Fit 1.00 PQ: 0 ANSI: 6 [ 75.896727] sd 4:0:0:0: Attached scsi generic sg3 type 0 [ 75.896928] sd 4:0:0:0: [sdd] 60062500 512-byte logical blocks: (30.8 GB/28.6 GiB) [ 75.900691] sd 4:0:0:0: [sdd] Write Protect is off [ 75.901941] sd 4:0:0:0: [sdd] Mode Sense: 43 00 00 00 [ 75.904268] sd 4:0:0:0: [sdd] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [ 75.913761] sdd: sdd1 sdd2 [ 75.917525] sd 4:0:0:0: [sdd] Attached SCSI removable disk [ 75.988485] sdc: sdc1 sdc2 sdc3 [ 75.991170] sd 5:0:0:0: [sdc] Attached SCSI disk [ 86.713499] xhci_hcd 0000:05:00.0: remove, state 1 [ 86.714589] usb usb4: USB disconnect, device number 1 [ 86.715705] usb 4-2: USB disconnect, device number 2 [ 86.718164] sd 5:0:0:0: [sdc] Synchronizing SCSI cache [ 86.920034] sd 5:0:0:0: [sdc] Synchronize Cache(10) failed: Result: hostbyte=0x07 driverbyte=0x00 [ 92.394569] xhci_hcd 0000:05:00.0: xHCI host controller not responding, assume dead [ 92.395073] xhci_hcd 0000:05:00.0: Timeout while waiting for configure endpoint command [ 92.395237] xhci_hcd 0000:05:00.0: WARN Can't disable streams for endpoint 0x81, streams are being disabled already [ 92.395828] xhci_hcd 0000:05:00.0: USB bus 4 deregistered [ 92.395886] xhci_hcd 0000:05:00.0: remove, state 1 [ 92.395891] usb usb3: USB disconnect, device number 1 [ 92.395893] usb 3-1: USB disconnect, device number 2 [ 92.447996] xhci_hcd 0000:05:00.0: Host halt failed, -19 [ 92.449988] xhci_hcd 0000:05:00.0: Host not accessible, reset failed. [ 92.452263] xhci_hcd 0000:05:00.0: USB bus 3 deregistered [ 92.513700] pci 0000:05:00.0: [1912:0015] type 00 class 0x0c0330 [ 92.515090] pci 0000:05:00.0: reg 0x10: [mem 0x00000000-0x00001fff 64bit] [ 92.516870] pci 0000:05:00.0: PME# supported from D0 D3hot D3cold [ 92.526800] pci 0000:05:00.0: BAR 0: assigned [mem 0xf1c00000-0xf1c01fff 64bit] [ 92.527638] pci 0000:05:00.0: enabling device (0000 -> 0002) [ 92.528719] xhci_hcd 0000:05:00.0: xHCI Host Controller [ 92.529530] xhci_hcd 0000:05:00.0: new USB bus registered, assigned bus number 3 [ 92.535686] xhci_hcd 0000:05:00.0: hcc params 0x014051cf hci version 0x100 quirks 0x00000090 [ 92.537037] hub 3-0:1.0: USB hub found [ 92.537746] hub 3-0:1.0: 2 ports detected [ 92.538561] xhci_hcd 0000:05:00.0: xHCI Host Controller [ 92.539278] xhci_hcd 0000:05:00.0: new USB bus registered, assigned bus number 4 [ 92.540078] usb usb4: We don't know the algorithms for LPM for this host, disabling LPM. [ 92.540987] hub 4-0:1.0: USB hub found [ 92.542107] hub 4-0:1.0: 2 ports detected [ 92.866671] usb 3-1: new high-speed USB device number 2 using xhci_hcd [ 93.014056] usb-storage 3-1:1.0: USB Mass Storage device detected [ 93.015844] scsi host4: usb-storage 3-1:1.0 [ 93.893861] usb 4-2: new SuperSpeed USB device number 2 using xhci_hcd [ 93.923092] scsi host5: uas [ 93.925387] scsi 5:0:0:0: Direct-Access Seagate M3 Portable 9300 PQ: 0 ANSI: 6 [ 93.930260] sd 5:0:0:0: Attached scsi generic sg2 type 0 [ 93.930573] sd 5:0:0:0: [sdc] 7814037167 512-byte logical blocks: (4.00 TB/3.64 TiB) [ 93.931488] sd 5:0:0:0: [sdc] 4096-byte physical blocks [ 93.932099] sd 5:0:0:0: [sdc] Write Protect is off [ 93.932636] sd 5:0:0:0: [sdc] Mode Sense: 4f 00 00 00 [ 93.933345] sd 5:0:0:0: [sdc] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA [ 93.934363] xhci_hcd 0000:05:00.0: ERROR Transfer event for unknown stream ring slot 3 ep 2 [ 93.935062] xhci_hcd 0000:05:00.0: @00000003f6feb5f0 00000000 00000000 1b000000 03038001 [ 94.028226] scsi 4:0:0:0: Direct-Access SanDisk Ultra Fit 1.00 PQ: 0 ANSI: 6 [ 94.030688] sd 4:0:0:0: Attached scsi generic sg3 type 0 [ 94.030842] sd 4:0:0:0: [sdd] 60062500 512-byte logical blocks: (30.8 GB/28.6 GiB) [ 94.033413] sd 4:0:0:0: [sdd] Write Protect is off [ 94.034156] sd 4:0:0:0: [sdd] Mode Sense: 43 00 00 00 [ 94.035670] sd 4:0:0:0: [sdd] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [ 94.042819] sdd: sdd1 sdd2 [ 94.047112] sd 4:0:0:0: [sdd] Attached SCSI removable disk [ 94.206000] sdc: sdc1 sdc2 sdc3 [ 94.209602] sd 5:0:0:0: [sdc] Attached SCSI disk from another kernel version: lspci -v 05:00.0 USB controller: Renesas Technology Corp. uPD720202 USB 3.0 Host Controller (rev 02) (prog-if 30 [XHCI]) Physical Slot: 1 Flags: bus master, fast devsel, latency 0, IRQ 19 Memory at f1c00000 (64-bit, non-prefetchable) [size=8K] Capabilities: <access denied> Kernel driver in use: xhci_hcd Kernel modules: xhci_pci This is on an Lenovo X220. Best, Christian -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
