Greg, On 28/03/18 00:26, Martin Blumenstingl wrote: > This is a follow-up to my previous series "initialize (multiple) PHYs > for a HCD": [0]. > > Roger Quadros reported [1] that it "is breaking low power cases on TI > SoCs when USB is in host mode". He further explains that "Not doing the > phy_exit() here [when entering suspend] leaves the clocks enabled on > our SoC and we're no longer able to reach low power states on system > suspend." > Chunfeng Yun from Mediatek noted [2] that we cannot unconditionally call > phy_exit while entering system suspend, because this would "disconnect > plugged devices on MTK platforms, due to re-initialize u2 phys when > resume" > > In the discussion (which followed Roger's bug report: [1]) Roger, > Chunfeng and me came to the conclusion that we can fix suspend on the > TI SoCs without breaking it on the Mediatek SoCs by extending the > suspend and resume code in usb/core/phy.c by checking whether the USB > controller can wake up the system (which is the case for the Mediatek > MTU3 controller, but now for the dwc3 controller used on the TI SoCs): > - if the controller can wake up the system (Mediatek MTU3 use-case) we > only call usb_phy_roothub_power_off (which calls phy_power_off) when > entering system suspend > - if the controller however cannot wake up the system (dwc3 on TI SoCs) > we additionally call usb_phy_roothub_exit (which calls phy_exit) when > entering system suspend > - (we undo the previous steps during system resume) > > The goal of this series is to fix the issue reported by Roger without > breaking suspend/resume on the Mediatek SoCs. > Since I neither have a TI nor a Mediatek device I am sending this as > RFC. I have tested it on an Amlogic Meson GXM board (Khadas VIM2) which > does NOT support suspend/resume yet. > > this should be applied on top of [3] "usb: core: phy: fix return value > of usb_phy_roothub_exit()" (even though there's no strict dependency, > this is the order I wrote the patches in). > > changes since RFC v3 at [6]: > - added Chunfeng Yun's Tested-by and Roger Quadros' Reviewed-by (thank > you!) > - dropped RFC prefix > > changes since RFC v2 at [5]: > - add missing INIT_LIST_HEAD call in usb_phy_roothub_add_phy (affects > patch #1 - spotted by Roger Quadros, thank you!) > - fixed swapped conditions using device_may_wakeup() in > usb_phy_roothub_resume because we need to call usb_phy_roothub_init > if the controller cannot wake up the device (affects patch #2, spotted > by Chunfeng Yun, thank you!) > - simplified the error condition to "undo" usb_phy_roothub_init if > usb_phy_roothub_power_on failed in usb_phy_roothub_resume (suggested > by Chunfeng Yun) > - updated the commit message (using Roger's wording) because (quote from > Roger "it doesn't prevent the system from entering suspend but just > prevents the system from reaching lowest power levels in the suspend > state." > > Changes since RFC v1 (blob attachments) at [4]: > - use device_may_wakeup instead of device_can_wakeup as suggested by > Roger Quadros > - use the controller device from hcd->self.controller as suggested by > Chunfeng Yun > - compile time fixes thanks to Roger Quadros > - if usb_phy_roothub_power_on in usb_phy_roothub_resume failes then > we now call usb_phy_roothub_exit to keep the PHYs in the correct > state if usb_phy_roothub_resume partially failed > > > [0] http://lists.infradead.org/pipermail/linux-amlogic/2018-March/006599.html > [1] http://lists.infradead.org/pipermail/linux-amlogic/2018-March/006737.html > [2] http://lists.infradead.org/pipermail/linux-amlogic/2018-March/006758.html > [3] http://lists.infradead.org/pipermail/linux-amlogic/2018-March/006819.html > [4] http://lists.infradead.org/pipermail/linux-amlogic/2018-March/006794.html > [5] http://lists.infradead.org/pipermail/linux-amlogic/2018-March/006820.html > [6] http://lists.infradead.org/pipermail/linux-amlogic/2018-March/006847.html > > Martin Blumenstingl (2): > usb: core: split usb_phy_roothub_{init,alloc} > usb: core: use phy_exit during suspend if wake up is not supported Gentle ping on this one. Without this system suspend/resume is broken on TI platforms. > > drivers/usb/core/hcd.c | 18 +++++++---- > drivers/usb/core/phy.c | 88 +++++++++++++++++++++++++++++++++++--------------- > drivers/usb/core/phy.h | 9 +++++- > 3 files changed, 82 insertions(+), 33 deletions(-) > -- cheers, -roger Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
