Hi,
> From: Mathias Nyman, Sent: Wednesday, January 31, 2018 9:29 PM
>
> On 31.01.2018 13:58, Yoshihiro Shimoda wrote:
> > The commit 37be66767e3c ("usb: hub: Fix auto-remount of safely removed
> > or ejected USB-3 devices") causes the following error when we
> > disconnected a usb 3.0 device on some environment (e.g. R-Car H3):
> >
> > xhci-hcd ee000000.usb: Cannot set link state.
> > usb usb8-port1: cannot disable (err = -32)
> >
> > According to Figure 35 in xhci spec, the PED (PORT_PE) will
> > be set to 0 after the usb3 root hub enters "Error" or "Disconnected"
> > state. So, this patch avoids the error messages to return -ENODEV when
> > asked to set the USB_PORT_FEAT_LINK_STATE feature to U3 and PORT_PE
> > was clear.
> >
> > Suggested-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx>
> > Suggested-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
> > Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
> > ---
> > drivers/usb/host/xhci-hub.c | 7 +++++--
> > 1 file changed, 5 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/usb/host/xhci-hub.c b/drivers/usb/host/xhci-hub.c
> > index 2a90229..7e95f9e 100644
> > --- a/drivers/usb/host/xhci-hub.c
> > +++ b/drivers/usb/host/xhci-hub.c
> > @@ -1229,8 +1229,11 @@ int xhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue,
> > * port link state above '3' (U3) and the port
> > * must be enabled.
> > */
> > - if ((temp & PORT_PE) == 0 ||
> > - (link_state > USB_SS_PORT_LS_U3)) {
> > + if ((temp & PORT_PE) == 0) {
> > + retval = -ENODEV;
> > + break;
> > + }
> > + if (link_state > USB_SS_PORT_LS_U3) {
> > xhci_warn(xhci, "Cannot set link state.\n");
> > goto error;
> > }
> >
>
> Thanks.
> Didn't notice this before writing a similar patch.
> Anyway, I'll make sure one of them goes forward after rc1
I think your patch is better than my patch.
So, I'll test your patch later.
Best regards,
Yoshihiro Shimoda
> -Mathias
��.n��������+%������w��{.n�����{���)�� jg��� �����ݢj����G���� ���j:+v���w�m������w�������h�����٥
