Hi, On 12/20/2017 11:19 AM, Kishon Vijay Abraham I wrote: > Hi, > > On Tuesday 12 December 2017 08:54 PM, Manu Gautam wrote: >> Hi, >> >> >> On 12/12/2017 5:13 PM, Kishon Vijay Abraham I wrote: >>> Hi, >>> >>> On Tuesday 21 November 2017 02:53 PM, Manu Gautam wrote: >>>> QCOM USB PHYs can monitor resume/remote-wakeup event in >>>> suspended state. However PHY driver must know current >>>> operational speed of PHY in order to set correct polarity of >>>> wakeup events for detection. E.g. QUSB2 PHY monitors DP/DM >>>> signals depending on speed is LS or FS/HS to detect resume. >>>> Similarly QMP USB3 PHY in SS mode should monitor RX >>>> terminations attach/detach and LFPS events depending on >>>> SSPHY is active or not. > Why not use a notification mechanism instead of adding new APIs in phy-core. > This will only bloat phy-core with APIs for a particular platform. Do you mean notifier_chains ? When we have multiple instances of USB PHYs then notifier chains are not of much help. For any platform glue or PHY driver it will be very difficult to figure out if notification received for speed was for same phy/bus or a different one. Using PHY callbacks looked more elegant to me. Additionally PHY drivers can also use this info decide power management policy e.g. if speed is INVALID then it means PHY is not in a session and it can enter deepest low power state. Additionally if you prefer set_speed name over notify_speed then I am ok with that as well so that it sounds more generic. > > Thanks > Kishon > -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
