Currently, xhci_plat is not set up properly when the parent device is an ACPI node. The conditions that xhci_plat_probe should satisfy are 1. xhci_plat comes from firmware 2. xhci_plat is child of a device from firmware (dwc3-plat) 3. xhci_plat is grandchild of a pci device (dwc3-pci) Case 2 is covered when the child is an OF node (by checking sysdev->parent->of_node), however, an ACPI parent will return NULL in the of_node check and will thus not result in sysdev being set to sysdev->parent [ 17.591549] xhci-hcd: probe of xhci-hcd.6.auto failed with error -5 This change adds a check for ACPI to completely allow for condition 2. This is done by first checking if the parent node is of type ACPI (e.g., dwc3-plat) and set sysdev to sysdev->parent if either of the two following conditions are met: 1: If fwnode is empty (in the case that platform_device_add_properties was not called on the allocated platform device) 2: fwnode exists but is not of type ACPI (this would happen if platform_device_add_properties was called on the allocated device. Instead of type FWNODE_ACPI, you would end up with FWNODE_PDATA) Cc: stable@xxxxxxxxxxxxxxx #4.12.x Cc: stable@xxxxxxxxxxxxxxx #4.13.x Signed-off-by: Adam Wallis <awallis@xxxxxxxxxxxxxx> --- Changes in v2: Incorporate the simplified fwnode check as suggested by Mathias drivers/usb/host/xhci-plat.c | 16 ++++++++++------ 1 file changed, 10 insertions(+), 6 deletions(-) diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c index c04144b..2087407 100644 --- a/drivers/usb/host/xhci-plat.c +++ b/drivers/usb/host/xhci-plat.c @@ -186,14 +186,18 @@ static int xhci_plat_probe(struct platform_device *pdev) * 2. xhci_plat is child of a device from firmware (dwc3-plat) * 3. xhci_plat is grandchild of a pci device (dwc3-pci) */ - sysdev = &pdev->dev; - if (sysdev->parent && !sysdev->of_node && sysdev->parent->of_node) - sysdev = sysdev->parent; + for (sysdev = &pdev->dev; sysdev; sysdev = sysdev->parent) { + if (is_of_node(sysdev->fwnode) || + is_acpi_device_node(sysdev->fwnode)) + break; #ifdef CONFIG_PCI - else if (sysdev->parent && sysdev->parent->parent && - sysdev->parent->parent->bus == &pci_bus_type) - sysdev = sysdev->parent->parent; + else if (sysdev->bus == &pci_bus_type) + break; #endif + } + + if (!sysdev) + sysdev = &pdev->dev; /* Try to set 64-bit DMA first */ if (WARN_ON(!sysdev->dma_mask)) -- Qualcomm Datacenter Technologies as an affiliate of Qualcomm Technologies, Inc. Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project. -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html