On 24.08.2017 05:53, Thang Q. Nguyen wrote:
On Sat, Aug 19, 2017 at 10:43 AM, Thang Q. Nguyen <tqnguyen@xxxxxxx> wrote:
From: "Thang Q. Nguyen" <tqnguyen@xxxxxxx>
For commit 4c39d4b949d3 ("usb: xhci: use bus->sysdev for DMA
configuration"), sysdev points to devices known to the system firmware
or hardware for DMA parameters.
However, the parent of the system firmware/hardware device checking
logic does not work in ACPI boot mode. This patch updates the formulation
to check this case in both DT and ACPI.
Signed-off-by: Tung Nguyen <tunguyen@xxxxxxx>
Signed-off-by: Thang Q. Nguyen <tqnguyen@xxxxxxx>
---
Change since v1:
- Update codes to work with kernel 4.13-rc5
---
drivers/usb/host/xhci-plat.c | 5 ++++-
1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/usb/host/xhci-plat.c b/drivers/usb/host/xhci-plat.c
index c04144b..1bb9729 100644
--- a/drivers/usb/host/xhci-plat.c
+++ b/drivers/usb/host/xhci-plat.c
@@ -187,7 +187,10 @@ static int xhci_plat_probe(struct platform_device *pdev)
* 3. xhci_plat is grandchild of a pci device (dwc3-pci)
*/
sysdev = &pdev->dev;
- if (sysdev->parent && !sysdev->of_node && sysdev->parent->of_node)
+ if (sysdev->parent && !is_of_node(sysdev->fwnode) &&
+ !is_acpi_device_node(sysdev->fwnode) &&
+ (is_of_node(sysdev->parent->fwnode) ||
+ is_acpi_device_node(sysdev->parent->fwnode)))
sysdev = sysdev->parent;
#ifdef CONFIG_PCI
else if (sysdev->parent && sysdev->parent->parent &&
--
1.8.3.1
Is there any comment about the patch?
With current kernel (4.13.0-rc6), booting the Linux using ACPI boot,
kernel is crashed right after probing the USB DWC3 driver with the
following messages:
That should work, but the if statements are getting quite elaborate.
How about replacing it all with:
- sysdev = &pdev->dev;
- if (sysdev->parent && !sysdev->of_node && sysdev->parent->of_node)
- sysdev = sysdev->parent;
-#ifdef CONFIG_PCI
- else if (sysdev->parent && sysdev->parent->parent &&
- sysdev->parent->parent->bus == &pci_bus_type)
- sysdev = sysdev->parent->parent;
-#endif
+
+ for (sysdev = &pdev->dev; sysdev; sysdev = sysdev->parent) {
+ if (is_of_node(sysdev->fwnode) ||
+ is_acpi_device_node(sysdev->fwnode))
+ break;
+ #ifdef CONFIG_PCI
+ else if (sysdev->bus == &pci_bus_type)
+ break;
+ #endif
+ }
+
+ if (!sysdev)
+ sysdev = &pdev->dev
Does that work for you?
-Mathias
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
