Hi, On 07/27/2017 03:55 PM, Felipe Balbi wrote: > Hi, > > Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx> writes: >> Xhci driver handles USB transaction errors on transfer events, >> but transaction errors are possible on address device command >> completion events as well. >> >> The xHCI specification (section 4.6.5) says: A USB Transaction >> Error Completion Code for an Address Device Command may be due >> to a Stall response from a device. Software should issue a Disable >> Slot Command for the Device Slot then an Enable Slot Command to >> recover from this error. >> >> This patch handles USB transaction errors on address command >> completion events. The related discussion threads can be found >> through below links. >> >> http://marc.info/?l=linux-usb&m=149362010728921&w=2 >> http://marc.info/?l=linux-usb&m=149252752825755&w=2 >> >> Suggested-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx> >> Signed-off-by: Lu Baolu <baolu.lu@xxxxxxxxxxxxxxx> >> --- >> drivers/usb/host/xhci.c | 5 +++++ >> 1 file changed, 5 insertions(+) >> >> diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c >> index d6b728d..95780f8 100644 >> --- a/drivers/usb/host/xhci.c >> +++ b/drivers/usb/host/xhci.c >> @@ -3822,6 +3822,11 @@ static int xhci_setup_device(struct usb_hcd *hcd, struct usb_device *udev, >> break; >> case COMP_USB_TRANSACTION_ERROR: >> dev_warn(&udev->dev, "Device not responding to setup %s.\n", act); >> + >> + ret = xhci_disable_slot(xhci, udev->slot_id); >> + if (!ret) >> + xhci_alloc_dev(hcd, udev); > aren't you leaking previously allocated virt_dev ? > When disable slot command completes, the command completion handler will release the previous allocated virt_dev. Best regards, Lu Baolu -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
