We should call dwc2_hsotg_enqueue_setup() after properly setting lx_state. Because it may cause error-out from dwc2_hsotg_enqueue_setup() due to wrong value in lx_state. Issue can be reproduced by loading driver while connected A-Connector (start in A-HOST mode) then disconnect A-Connector to switch to B-DEVICE. Signed-off-by: Vardan Mikayelyan <mvardan@xxxxxxxxxxxx> --- drivers/usb/dwc2/gadget.c | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) diff --git a/drivers/usb/dwc2/gadget.c b/drivers/usb/dwc2/gadget.c index 98a4a79..9322f80 100644 --- a/drivers/usb/dwc2/gadget.c +++ b/drivers/usb/dwc2/gadget.c @@ -3402,12 +3402,6 @@ void dwc2_hsotg_core_init_disconnected(struct dwc2_hsotg *hsotg, dwc2_writel(dwc2_hsotg_ep0_mps(hsotg->eps_out[0]->ep.maxpacket) | DXEPCTL_USBACTEP, hsotg->regs + DIEPCTL0); - dwc2_hsotg_enqueue_setup(hsotg); - - dev_dbg(hsotg->dev, "EP0: DIEPCTL0=0x%08x, DOEPCTL0=0x%08x\n", - dwc2_readl(hsotg->regs + DIEPCTL0), - dwc2_readl(hsotg->regs + DOEPCTL0)); - /* clear global NAKs */ val = DCTL_CGOUTNAK | DCTL_CGNPINNAK; if (!is_usb_reset) @@ -3418,6 +3412,12 @@ void dwc2_hsotg_core_init_disconnected(struct dwc2_hsotg *hsotg, mdelay(3); hsotg->lx_state = DWC2_L0; + + dwc2_hsotg_enqueue_setup(hsotg); + + dev_dbg(hsotg->dev, "EP0: DIEPCTL0=0x%08x, DOEPCTL0=0x%08x\n", + dwc2_readl(hsotg->regs + DIEPCTL0), + dwc2_readl(hsotg->regs + DOEPCTL0)); } static void dwc2_hsotg_core_disconnect(struct dwc2_hsotg *hsotg) -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
