David Brownell wrote:
Now that the musb build fixes for DaVinci got merged (RC3?), kick in
the other bits needed to get it finally *working* in mainline:
- Use clk_enable()/clk_disable() ... the "always enable USB clocks"
code this originally relied on has since been removed.
- Initialize the USB device only after the relevant I2C GPIOs are
available, so the host side can properly enable VBUS.
- Tweak init sequencing to cope with mainline's relatively late init
of the I2C system bus for power switches, transceivers, and so on.
Sanity tested on DM6664 EVM for host and peripheral modes; that system
won't boot with CONFIG_PM enabled, so OTG can't yet be tested. Also
verified on OMAP3.
(Unrelated: correct the MODULE_PARM_DESC spelling of musb_debug.)
As usual, an unrelated fragment in the same patch. :-P
Signed-off-by: David Brownell <dbrownell@xxxxxxxxxxxxxxxxxxxxx>
--- a/arch/arm/mach-davinci/board-evm.c
+++ b/arch/arm/mach-davinci/board-evm.c
@@ -311,6 +311,9 @@ evm_u35_setup(struct i2c_client *client,
gpio_request(gpio + 7, "nCF_SEL");
gpio_direction_output(gpio + 7, 1);
+ /* irlml6401 sustains over 3A, switches 5V in under 8 msec */
+ setup_usb(500, 8);
+
return 0;
}
@@ -417,9 +420,6 @@ static __init void davinci_evm_init(void
platform_add_devices(davinci_evm_devices,
ARRAY_SIZE(davinci_evm_devices));
evm_init_i2c();
-
- /* irlml6401 sustains over 3A, switches 5V in under 8 msec */
- setup_usb(500, 8);
}
static __init void davinci_evm_irq_init(void)
--- a/arch/arm/mach-davinci/clock.c
+++ b/arch/arm/mach-davinci/clock.c
@@ -231,6 +231,11 @@ static struct clk davinci_clks[] = {
.lpsc = DAVINCI_LPSC_GPIO,
},
{
+ .name = "usb",
Why not "USBCLK", like most of the other clock names?
+ .rate = &commonrate,
+ .lpsc = DAVINCI_LPSC_USB,
+ },
+ {
.name = "AEMIFCLK",
.rate = &commonrate,
.lpsc = DAVINCI_LPSC_AEMIF,
WBR, Sergei
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
