The adaptor on Analog Devices EVAL-ADXL362Z development board is used
to flash and debug firmware of on-board Renesas RL78/G13 MCU.
Also added support of the 153600 baud rate, since the stock firmware
uses it.
Signed-off-by: Maksim Salau <maksim.salau@xxxxxxxxx>
---
Changes in v2:
* mentioned additional baudrate in the commit message.
drivers/usb/serial/upd78f0730.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/serial/upd78f0730.c b/drivers/usb/serial/upd78f0730.c
index 55b9a18..f1e6c07 100644
--- a/drivers/usb/serial/upd78f0730.c
+++ b/drivers/usb/serial/upd78f0730.c
@@ -17,7 +17,7 @@
* - stop bits: 1 or 2
* - parity: even, odd or none
* - flow control: none
- * - baud rates: 0, 2400, 4800, 9600, 19200, 38400, 57600, 115200
+ * - baud rates: 0, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 153600
* - signals: DTR, RTS and BREAK
*/
@@ -34,6 +34,7 @@
static const struct usb_device_id id_table[] = {
{ USB_DEVICE(0x045B, 0x0212) }, /* YRPBRL78G13, YRPBRL78G14 */
{ USB_DEVICE(0x0409, 0x0063) }, /* V850ESJX3-STICK */
+ { USB_DEVICE(0x064B, 0x7825) }, /* Analog Devices EVAL-ADXL362Z-DB */
{}
};
@@ -288,7 +289,7 @@ static speed_t upd78f0730_get_baud_rate(struct tty_struct *tty)
{
const speed_t baud_rate = tty_get_baud_rate(tty);
const speed_t supported[] = {
- 0, 2400, 4800, 9600, 19200, 38400, 57600, 115200
+ 0, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 153600
};
int i;
--
2.9.3
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
