Dear Jon ,
We can reproduce your issue on x86 Linux kernel 4.9.0-rc system in our site
and modified the following code can fix this issue. Please let us know if
you still have problems. Thanks a lot.
static void ax88772_suspend(struct usbnet *dev)
{
struct asix_common_private *priv = dev->driver_priv;
u16 medium;
/* Stop MAC operation */
- medium = asix_read_medium_status(dev, 0);
+ medium = asix_read_medium_status(dev, 1);
medium &= ~AX_MEDIUM_RE;
- asix_write_medium_mode(dev, medium, 0);
+ asix_write_medium_mode(dev, medium, 1);
netdev_dbg(dev->net, "ax88772_suspend: medium=0x%04x\n",
- asix_read_medium_status(dev, 0));
+ asix_read_medium_status(dev, 1));
/* Preserve BMCR for restoring */
priv->presvd_phy_bmcr =
asix_mdio_read_nopm(dev->net, dev->mii.phy_id, MII_BMCR);
/* Preserve ANAR for restoring */
priv->presvd_phy_advertise =
asix_mdio_read_nopm(dev->net, dev->mii.phy_id,
MII_ADVERTISE);
}
---
Best regards,
Allan Chou
Technical Support Division
ASIX Electronics Corporation
TEL: 886-3-5799500 ext.228
FAX: 886-3-5799558
E-mail: allan@xxxxxxxxxxx
http://www.asix.com.tw/
-----Original Message-----
From: Jon Hunter [mailto:jonathanh@xxxxxxxxxx]
Sent: Tuesday, November 22, 2016 11:34 PM
To: allan@xxxxxxxxxxx; robert.foss@xxxxxxxxxxxxx; freddy@xxxxxxxxxxx;
Dean_Jenkins@xxxxxxxxxx; Mark_Craske@xxxxxxxxxx; davem@xxxxxxxxxxxxx;
ivecera@xxxxxxxxxx; john.stultz@xxxxxxxxxx; vpalatin@xxxxxxxxxxxx;
stephen@xxxxxxxxxxxxxxxxxx; grundler@xxxxxxxxxxxx; changchias@xxxxxxxxx;
andrew@xxxxxxx; tremyfr@xxxxxxxxx; colin.king@xxxxxxxxxxxxx;
linux-usb@xxxxxxxxxxxxxxx; netdev@xxxxxxxxxxxxxxx;
linux-kernel@xxxxxxxxxxxxxxx; vpalatin@xxxxxxxxxx
Subject: Re: [PATCH v3 3/5] net: asix: Fix AX88772x resume failures
Hi Allan,
On 18/11/16 15:09, Jon Hunter wrote:
> Hi Allan,
>
> On 14/11/16 09:45, ASIX_Allan [Office] wrote:
>> Hi Jon,
>>
>> Please help to double check if the USB host controller of your Terga
>> platform had been powered OFF while running the ax88772_suspend()
>> routine or not?
>
> Sorry for the delay. Today I set up a local board to reproduce this on
> and was able to recreate the same problem. The Tegra xhci driver does
> not power off during suspend and simply calls xhci_suspend(). I also
> checked vbus to see if it was turning off but it is not. Furthermore I
> don't see a new USB device detected after the error and so I don't see
> any evidence that it ever disconnects.
In an attempt to isolate if this is a Tegra issue or not, I recompiled
v4.9-rc6 for x86 and I was able to reproduce the problem on my desktop ...
[ 256.030060] PM: Syncing filesystems ... done.
[ 256.113925] PM: Preparing system for sleep (mem) [ 256.114119] Freezing
user space processes ... (elapsed 0.002 seconds) done.
[ 256.116701] Freezing remaining freezable tasks ... (elapsed 0.001
seconds) done.
[ 256.118041] PM: Suspending system (mem) [ 256.118058] Suspending
console(s) (use no_console_suspend to debug) [ 256.118324] asix 1-1.2:1.0
eth2: Failed to read reg index 0x0000: -19 [ 256.118327] asix 1-1.2:1.0
eth2: Error reading Medium Status register: ffffffed [ 256.118329] asix
1-1.2:1.0 eth2: Failed to write reg index 0x0000: -19 [ 256.118332] asix
1-1.2:1.0 eth2: Failed to write Medium Mode mode to 0xfeed: ffffffed [
256.118374] sd 0:0:0:0: [sda] Synchronizing SCSI cache [ 256.118471] sd
0:0:0:0: [sda] Stopping disk [ 256.152992] hpet1: lost 1 rtc interrupts [
256.153893] serial 00:06: disabled [ 256.153899] serial 00:06: System
wakeup disabled by ACPI [ 256.154068] e1000e: EEE TX LPI TIMER: 00000011 [
256.628281] PM: suspend of devices complete after 509.782 msecs [
256.628620] PM: late suspend of devices complete after 0.336 msecs [
256.629366] ehci-pci 0000:00:1d.0: System wakeup enabled by ACPI [
256.629595] tg3 0000:03:00.0: System wakeup enabled by ACPI [ 256.629601]
ehci-pci 0000:00:1a.0: System wakeup enabled by ACPI [ 256.629652] e1000e
0000:00:19.0: System wakeup enabled by ACPI [ 256.629812] xhci_hcd
0000:00:14.0: System wakeup enabled by ACPI [ 256.648347] PM: noirq suspend
of devices complete after 19.713 msecs [ 256.648685] ACPI: Preparing to
enter system sleep state S3 [ 256.668275] PM: Saving platform NVS memory [
256.668283] Disabling non-boot CPUs ...
To reproduce this, I did the following:
1. Connect the asix device and noted the net interface (ie. eth2) 2.
Disabled the interface (ie. sudo ifconfig eth2 down) 3. Ran a suspend-resume
cycle using rtcwake (eg. sudo rtcwake -d rtc0 -m mem -s 5)
Cheers
Jon
--
nvpublic
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
