Hi Andreas,
Thank you for the patch.
On Wednesday 03 Aug 2016 17:38:51 Andreas Kemnade wrote:
> The code assumes that omap2430_musb_enable() and
> omap2430_musb_disable() are called in a balanced way.
> That fact is broken by the fact that musb_init_controller() calls
> musb_platform_disable() to switch from unknown state to off state
> on initialisation.
>
> That means that phy_power_off() is called first so that
> phy->power_count gets -1 and the phy is not enabled on phy_power_on().
> So when usb gadget is started the phy is not powered on.
> Depending on the phy used that caused various problems.
> Besides of causing usb problems, that can also have side effects.
>
> In the case of using the phy_twl4030, that prevents also charging
> the battery via usb (using twl4030_charger) and so makes further
> kernel debugging hard.
> The problem was seen with 4.7 on an openphoenux gta04. It has a DM3730
> SoC and a TPS65950 companion. phy->power never became 1
> and so the usb did get powered on.
>
> The patch prevents phy_power_off() from being called when
> it is already off.
>
> Signed-off-by: Andreas Kemnade <andreas@xxxxxxxxxxxx>
This fixes USB gadget operation on the Panda board.
Fixes: a83e17d0f73b ("usb: musb: Improve PM runtime and phy handling for 2430
glue layer")
Tested-by: Laurent Pinchart <laurent.pinchart@xxxxxxxxxxxxxxxx>
> ---
> changes in v2:
> improved commit message
>
> drivers/usb/musb/omap2430.c | 7 ++++---
> 1 file changed, 4 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/omap2430.c
> index 0b4cec9..c1a2b7b 100644
> --- a/drivers/usb/musb/omap2430.c
> +++ b/drivers/usb/musb/omap2430.c
> @@ -413,9 +413,10 @@ static void omap2430_musb_disable(struct musb *musb)
> struct device *dev = musb->controller;
> struct omap2430_glue *glue = dev_get_drvdata(dev->parent);
>
> - if (!WARN_ON(!musb->phy))
> - phy_power_off(musb->phy);
> -
> + if (glue->enabled) {
> + if (!WARN_ON(!musb->phy))
> + phy_power_off(musb->phy);
> + }
> if (glue->status != MUSB_UNKNOWN)
> omap_control_usb_set_mode(glue->control_otghs,
> USB_MODE_DISCONNECT);
--
Regards,
Laurent Pinchart
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
