From: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
This patch (as1199) changes the initial wakeup settings for PCI USB
host controllers. The controllers are marked as capable of waking the
system, but wakeup is not enabled by default.
It turns out that enabling wakeup for USB host controllers has a lot
of bad consequences. As the simplest example, if a USB mouse or
keyboard is unplugged immediately after the computer is put to sleep,
the unplug will cause the system to wake back up again! We are better
off marking them as wakeup-capable and leaving wakeup disabled.
Signed-off-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
Reported-by: Rafael J. Wysocki <rjw@xxxxxxx>
CC: David Brownell <david-b@xxxxxxxxxxx>
Cc: stable <stable@xxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxx>
---
drivers/usb/core/hcd-pci.c | 1 -
drivers/usb/host/ehci-pci.c | 2 +-
drivers/usb/host/ohci-hcd.c | 8 +++-----
3 files changed, 4 insertions(+), 7 deletions(-)
diff --git a/drivers/usb/core/hcd-pci.c b/drivers/usb/core/hcd-pci.c
index 507741e..9943278 100644
--- a/drivers/usb/core/hcd-pci.c
+++ b/drivers/usb/core/hcd-pci.c
@@ -128,7 +128,6 @@ int usb_hcd_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
}
pci_set_master(dev);
- device_set_wakeup_enable(&dev->dev, 1);
retval = usb_add_hcd(hcd, dev->irq, IRQF_DISABLED | IRQF_SHARED);
if (retval != 0)
diff --git a/drivers/usb/host/ehci-pci.c b/drivers/usb/host/ehci-pci.c
index bdc6e86..9faa5c8 100644
--- a/drivers/usb/host/ehci-pci.c
+++ b/drivers/usb/host/ehci-pci.c
@@ -230,7 +230,7 @@ static int ehci_pci_setup(struct usb_hcd *hcd)
pci_read_config_word(pdev, 0x62, &port_wake);
if (port_wake & 0x0001) {
dev_warn(&pdev->dev, "Enabling legacy PCI PM\n");
- device_init_wakeup(&pdev->dev, 1);
+ device_set_wakeup_capable(&pdev->dev, 1);
}
}
diff --git a/drivers/usb/host/ohci-hcd.c b/drivers/usb/host/ohci-hcd.c
index 65a9609..5cf5f1e 100644
--- a/drivers/usb/host/ohci-hcd.c
+++ b/drivers/usb/host/ohci-hcd.c
@@ -593,12 +593,10 @@ static int ohci_run (struct ohci_hcd *ohci)
* to be checked in case boot firmware (BIOS/SMM/...) has set up
* wakeup in a way the bus isn't aware of (e.g., legacy PCI PM).
* If the bus glue detected wakeup capability then it should
- * already be enabled. Either way, if wakeup should be enabled
- * but isn't, we'll enable it now.
+ * already be enabled; if so we'll just enable it again.
*/
- if ((ohci->hc_control & OHCI_CTRL_RWC) != 0
- && !device_can_wakeup(hcd->self.controller))
- device_init_wakeup(hcd->self.controller, 1);
+ if ((ohci->hc_control & OHCI_CTRL_RWC) != 0)
+ device_set_wakeup_capable(hcd->self.controller, 1);
switch (ohci->hc_control & OHCI_CTRL_HCFS) {
case OHCI_USB_OPER:
--
1.6.0.2
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
