Dear Rob,
On 2016/7/11 22:54, Rob Herring wrote:
On Fri, Jul 08, 2016 at 02:33:09PM +0200, Heiko Stuebner wrote:
Hi William,
Am Donnerstag, 7. Juli 2016, 10:54:24 schrieb William Wu:
Add a quirk to configure the core to support the
UTMI+ PHY with an 8- or 16-bit interface. UTMI+ PHY
interface is hardware property, and it's platform
dependent. Normall, the PHYIf can be configured
during coreconsultant. But for some specific usb
cores(e.g. rk3399 soc dwc3), the default PHYIf
configuration value is fault, so we need to
reconfigure it by software.
And refer to the dwc3 databook, the GUSB2PHYCFG.USBTRDTIM
must be set to the corresponding value according to
the UTMI+ PHY interface.
Signed-off-by: William Wu <william.wu@xxxxxxxxxxxxxx>
---
[...]
diff --git a/Documentation/devicetree/bindings/usb/dwc3.txt
b/Documentation/devicetree/bindings/usb/dwc3.txt index 020b0e9..8d7317d
100644
--- a/Documentation/devicetree/bindings/usb/dwc3.txt
+++ b/Documentation/devicetree/bindings/usb/dwc3.txt
@@ -42,6 +42,10 @@ Optional properties:
- snps,dis-u2-freeclk-exists-quirk: when set, clear the
u2_freeclk_exists in GUSB2PHYCFG, specify that USB2 PHY doesn't provide
a free-running PHY clock.
+ - snps,phyif-utmi-quirk: when set core will set phyif UTMI+ interface.
+ - snps,phyif-utmi: the value to configure the core to support a UTMI+
PHY + with an 8- or 16-bit interface. Value 0 select 8-bit
+ interface, value 1 select 16-bit interface.
maybe
snps,phyif-utmi-width = <8> or <16>;
Seems like this could be common. Any other bindings have something
similar already? If not "utmi-width" is fine.
It seems that there's not any dwc3 binding similar to this.
So I prefer to use “utmi-width”. :-)
devicetree is about describing the hardware, not the things that get written
to registers :-) . The conversion from the described width to the register
value can easily be done in the driver.
Also I don't think you need two properties for this. If the snps,phyif-utmi
property is specified it indicates that you want to manually set the width
and if it is absent you want to use the IC default. All functions reading
property-values indicate if the property is missing.
Agreed.
Rob
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
