On Thu, Jul 07, 2016 at 03:21:06PM -0700, Stephen Boyd wrote:
> We need to pick the correct phy at runtime based on how the SoC
> has been wired onto the board. If the secondary phy is used, take
> it out of reset and mux over to it by writing into the TCSR
> register. Make sure to do this on reset too, because this
> register is reset to the default value (primary phy) after the
> RESET bit is set in USBCMD.
>
> Cc: Peter Chen <peter.chen@xxxxxxx>
> Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
> Signed-off-by: Stephen Boyd <stephen.boyd@xxxxxxxxxx>
> ---
> drivers/usb/chipidea/ci_hdrc_msm.c | 67 +++++++++++++++++++++++++++++++++++---
> 1 file changed, 62 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/usb/chipidea/ci_hdrc_msm.c b/drivers/usb/chipidea/ci_hdrc_msm.c
> index 7e870a253f55..7708bee3ff3e 100644
> --- a/drivers/usb/chipidea/ci_hdrc_msm.c
> +++ b/drivers/usb/chipidea/ci_hdrc_msm.c
> @@ -8,29 +8,44 @@
> #include <linux/module.h>
> #include <linux/platform_device.h>
> #include <linux/pm_runtime.h>
> -#include <linux/usb/gadget.h>
> #include <linux/usb/chipidea.h>
> #include <linux/clk.h>
> #include <linux/reset.h>
> +#include <linux/mfd/syscon.h>
> +#include <linux/regmap.h>
> +#include <linux/io.h>
>
> #include "ci.h"
>
> #define HS_PHY_AHB_MODE 0x0098
>
> +/* Vendor base starts at 0x200 beyond CI base */
> +#define HS_PHY_SEC_CTRL 0x0078
> +#define HS_PHY_DIG_CLAMP_N BIT(16)
> +
Keep alignment
> struct ci_hdrc_msm {
> struct platform_device *ci;
> struct clk *core_clk;
> struct clk *iface_clk;
> struct clk *fs_clk;
> + bool secondary_phy;
> + void __iomem *base;
> };
>
> static void ci_hdrc_msm_notify_event(struct ci_hdrc *ci, unsigned event)
> {
> - struct device *dev = ci->gadget.dev.parent;
> + struct device *dev = ci->dev->parent;
> + struct ci_hdrc_msm *msm_ci = dev_get_drvdata(dev);
>
> switch (event) {
> case CI_HDRC_CONTROLLER_RESET_EVENT:
> dev_dbg(dev, "CI_HDRC_CONTROLLER_RESET_EVENT received\n");
> + if (msm_ci->secondary_phy) {
> + u32 val = readl_relaxed(msm_ci->base + HS_PHY_SEC_CTRL);
> + val |= HS_PHY_DIG_CLAMP_N;
> + writel_relaxed(val, msm_ci->base + HS_PHY_SEC_CTRL);
> + }
> +
> /* use AHB transactor, allow posted data writes */
> hw_write_id_reg(ci, HS_PHY_AHB_MODE, 0xffffffff, 0x8);
> usb_phy_init(ci->usb_phy);
> @@ -59,6 +74,39 @@ static struct ci_hdrc_platform_data ci_hdrc_msm_platdata = {
> .notify_event = ci_hdrc_msm_notify_event,
> };
>
> +static int ci_hdrc_msm_mux_phy(struct ci_hdrc_msm *ci,
> + struct platform_device *pdev)
> +{
> + struct regmap *regmap;
> + struct device *dev = &pdev->dev;
> + struct of_phandle_args args;
> + u32 val;
> + int ret;
> +
> + ret = of_parse_phandle_with_fixed_args(dev->of_node, "phy-select", 2, 0,
> + &args);
> + if (ret)
> + return 0;
> +
> + regmap = syscon_node_to_regmap(args.np);
> + of_node_put(args.np);
> + if (IS_ERR(regmap))
> + return PTR_ERR(regmap);
> +
> + ret = regmap_write(regmap, args.args[0], args.args[1]);
> + if (ret)
> + return ret;
> +
> + ci->secondary_phy = !!args.args[1];
> + if (ci->secondary_phy) {
> + val = readl_relaxed(ci->base + HS_PHY_SEC_CTRL);
> + val |= HS_PHY_DIG_CLAMP_N;
> + writel_relaxed(val, ci->base + HS_PHY_SEC_CTRL);
> + }
> +
> + return 0;
> +}
> +
> static int ci_hdrc_msm_probe(struct platform_device *pdev)
> {
> struct ci_hdrc_msm *ci;
> @@ -66,6 +114,7 @@ static int ci_hdrc_msm_probe(struct platform_device *pdev)
> struct usb_phy *phy;
> struct clk *clk;
> struct reset_control *reset;
> + struct resource *res;
> int ret;
>
> dev_dbg(&pdev->dev, "ci_hdrc_msm_probe\n");
> @@ -105,6 +154,11 @@ static int ci_hdrc_msm_probe(struct platform_device *pdev)
> ci->fs_clk = NULL;
> }
>
> + res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
> + ci->base = devm_ioremap_resource(&pdev->dev, res);
> + if (!ci->base)
> + return -ENOMEM;
> +
> ret = clk_prepare_enable(ci->fs_clk);
> if (ret)
> return ret;
> @@ -123,9 +177,12 @@ static int ci_hdrc_msm_probe(struct platform_device *pdev)
> if (ret)
> goto err_iface;
>
> - plat_ci = ci_hdrc_add_device(&pdev->dev,
> - pdev->resource, pdev->num_resources,
> - &ci_hdrc_msm_platdata);
> + ret = ci_hdrc_msm_mux_phy(ci, pdev);
> + if (ret)
> + goto err_mux;
> +
> + plat_ci = ci_hdrc_add_device(&pdev->dev, pdev->resource,
> + pdev->num_resources, &ci_hdrc_msm_platdata);
The above line has not changed.
After fixing above, you can add my ack.
Acked-by: Peter Chen <peter.chen@xxxxxxx>
--
Best Regards,
Peter Chen
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
