The ULPI phy on qcom platforms needs to be initialized and powered on after a USB reset and before we toggle the run/stop bit. Otherwise, the phy locks up and doesn't work properly. Therefore, add a flag to skip any phy power management in the core layer, leaving it up to the glue driver to manage. Cc: Peter Chen <peter.chen@xxxxxxx> Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Stephen Boyd <stephen.boyd@xxxxxxxxxx> --- drivers/usb/chipidea/core.c | 6 ++++++ include/linux/usb/chipidea.h | 1 + 2 files changed, 7 insertions(+) diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c index 01390e02ee53..532085a096d9 100644 --- a/drivers/usb/chipidea/core.c +++ b/drivers/usb/chipidea/core.c @@ -361,6 +361,9 @@ static int _ci_usb_phy_init(struct ci_hdrc *ci) */ static void ci_usb_phy_exit(struct ci_hdrc *ci) { + if (ci->platdata->flags & CI_HDRC_OVERRIDE_PHY_CONTROL) + return; + if (ci->phy) { phy_power_off(ci->phy); phy_exit(ci->phy); @@ -379,6 +382,9 @@ static int ci_usb_phy_init(struct ci_hdrc *ci) { int ret; + if (ci->platdata->flags & CI_HDRC_OVERRIDE_PHY_CONTROL) + return 0; + switch (ci->platdata->phy_mode) { case USBPHY_INTERFACE_MODE_UTMI: case USBPHY_INTERFACE_MODE_UTMIW: diff --git a/include/linux/usb/chipidea.h b/include/linux/usb/chipidea.h index f9be467d6695..d07b162073f7 100644 --- a/include/linux/usb/chipidea.h +++ b/include/linux/usb/chipidea.h @@ -57,6 +57,7 @@ struct ci_hdrc_platform_data { #define CI_HDRC_OVERRIDE_AHB_BURST BIT(9) #define CI_HDRC_OVERRIDE_TX_BURST BIT(10) #define CI_HDRC_OVERRIDE_RX_BURST BIT(11) +#define CI_HDRC_OVERRIDE_PHY_CONTROL BIT(12) /* Glue layer manages phy */ enum usb_dr_mode dr_mode; #define CI_HDRC_CONTROLLER_RESET_EVENT 0 #define CI_HDRC_CONTROLLER_STOPPED_EVENT 1 -- 2.9.0.rc2.8.ga28705d -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html