* Bin Liu <b-liu@xxxxxx> [160513 14:05]:
> Hi,
>
> On Wed, May 11, 2016 at 05:53:11PM -0700, Tony Lindgren wrote:
> > At least 2430 glue layer pulls d+ high on start up even if there are
> > no gadgets configured. This is bad at least for anything using a separate
> > battery charger chip as it can confuse the charger detection.
> >
> > Let's fix the issue by getting rid of omap2430_musb_set_mode() and only
>
> By doing so, you lost the feature of switching mode from sysfs, I am not
> sure if there is anyone using it though, still, it is a regression.
Oh right, that's a good point.
How about we change musb_core to call the optional set_mode() if implemented,
and then set the session bit in host mode only? That way we can get rid of
the musb core tinkering in the glue layer drivers eventually?
> > write session bit in omap2430_musb_enable().
>
> I don't think session bit needs to be set in _enable(), musb_start() in
> core takes care of this bit.
OK sounds like that should just work then.
> > -static int omap2430_musb_set_mode(struct musb *musb, u8 musb_mode)
> > -{
> > - u8 devctl = musb_readb(musb->mregs, MUSB_DEVCTL);
> > -
> > - devctl |= MUSB_DEVCTL_SESSION;
> > - musb_writeb(musb->mregs, MUSB_DEVCTL, devctl);
>
> In stead of removing it, session bit should only be set when musb_mode
> == MUSB_HOST, will this fix the D+ pullup problem?
Good point, I forgot about it being specific to host mode. I'll check.
> > static inline void omap2430_low_level_exit(struct musb *musb)
> > {
> > u32 l;
> > @@ -428,6 +418,9 @@ static void omap2430_musb_enable(struct musb *musb)
> >
> > case MUSB_VBUS_VALID:
> > omap_control_usb_set_mode(glue->control_otghs, USB_MODE_DEVICE);
> > + devctl = musb_readb(musb->mregs, MUSB_DEVCTL);
> > + devctl |= MUSB_DEVCTL_SESSION;
> > + musb_writeb(musb->mregs, MUSB_DEVCTL, devctl);
>
> session bit is only set for host mode, VBUS_VALID is not a signal for
> host mode. So you don't have to set the bit here.
OK thanks.
Tony
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
