Hi, > From: linux-renesas-soc-owner@xxxxxxxxxxxxxxx [mailto:linux-renesas-soc-owner@xxxxxxxxxxxxxxx] On Behalf Of Yoshihiro > Shimoda > Sent: Thursday, April 21, 2016 7:28 PM > > Hi Felipe, > > > From: Felipe Balbi > > Sent: Thursday, April 21, 2016 7:19 PM > > > > Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> writes: > > > > > Hi Felipe, > > > > > >> From: Felipe Balbi > > >> Sent: Thursday, April 21, 2016 7:05 PM > > >> > > >> Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> writes: > > >> > > >> > If kernel configuration is CONFIG_USB_XHCI_PLATFORM=y and > > >> > CONFIG_USB_XHCI_RCAR is not set, R-Car Gen2/3 will cause long wait > > >> > in xhci_reset() because such SoCs need specific initialization. > > >> > > >> where is the delay coming from exactly ? > > > > > > The delay is coming from the following code: > > > > > > ret = xhci_handshake(&xhci->op_regs->command, > > > CMD_RESET, 0, 10 * 1000 * 1000); > > > if (ret) > > > return ret; > > > > okay, and why does reset fail ? > > Oops, I don't know why. So, I will investigate it. > > > > And, kernel log is the following: > > > > > > [ 1.565605] xhci-hcd ee000000.usb: xHCI Host Controller > > > [ 1.570636] xhci-hcd ee000000.usb: new USB bus registered, assigned bus number 5 > > > [ 22.270160] xhci-hcd ee000000.usb: can't setup: -110 > > > [ 22.274931] xhci-hcd ee000000.usb: USB bus 5 deregistered > > > [ 22.280158] xhci-hcd: probe of ee000000.usb failed with error -110 > > > > > > The timestamp is strange to me. But, logs of R-Car H3 (ES1.0) and > > > R-Car H2 were the same. > > > > yeah, seems like your system timer is counting twice for each tick. > > Yes, I will investigate this later. > > > > Should I revise the commit log in detail? > > > > Sure, but let's first why this is the case. It's unclear, to me at > > least, why reset fails. > > I understood it. I will investigate why reset fails first. According to the HW team of R-Car SoCs, the firmware of R-Car USB 3.0 host controller will control the reset. So, if the xhci-rcar driver doesn't do firmware downloading, the reset of USB3.0 host controller doesn't work correctly. The HW team intends to describe this specification on next datasheet revision. (In other words, the current datasheet doesn't mention exactly about this.) So, I will revise the commit log and submit such a patch later. Best regards, Yoshihiro Shimoda > Best regards, > Yoshihiro Shimoda > > > -- > > balbi -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
