On Sat, Jan 10, 2009 at 03:38:47AM +0300, Anton Vorontsov wrote: > On Fri, Jan 09, 2009 at 12:29:14PM -0800, akpm@xxxxxxxxxxxxxxxxxxxx wrote: > > From: Anton Vorontsov <avorontsov@xxxxxxxxxxxxx> > > > > Add support for the FHCI USB controller, as found in the Freescale MPC836x > > and MPC832x processors. It can support Full or Low speed modes. > > > > Quite a lot the hardware is doing by itself (SOF generation, CRC > > generation and checking), though scheduling and retransmission is on > > software's shoulders. > > > > This controller does not integrate the root hub, so this driver also fakes > > one-port hub. External hub is required to support more than one device. > > > > Signed-off-by: Anton Vorontsov <avorontsov@xxxxxxxxxxxxx> > > Cc: Greg Kroah-Hartman <greg@xxxxxxxxx> > > Cc: David Brownell <dbrownell@xxxxxxxxxxxxxxxxxxxxx> > > Cc: Timur Tabi <timur@xxxxxxxxxxxxx> > > Cc: Li Yang <leoli@xxxxxxxxxxxxx> > > Cc: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx> > > Signed-off-by: Andrew Morton <akpm@xxxxxxxxxxxxxxxxxxxx> > > --- > > This version was superseded by that one: > > [PATCH v2] USB: Driver for Freescale QUICC Engine USB Host Controller > http://lkml.org/lkml/2008/12/24/80 > > Greg, I can resend it if it's more convenient for you. Please do, so I know I have the right one. thanks, greg k-h -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
