Yan Li wrote:
Hello List,
By default CONFIG_USB_SUSPEND is not enabled and today I got bite by
this when I got a new WDC My Book hard drive. I have no way to unplug
it safely, according to it's manual, with a kernel that doesn't have
CONFIG_USB_SUSPEND=y.
On it's manual read "you should unplug and remove the device only when
the light is off." On Linux unmounting it won't turn it's light off
and I can feel it's motor is still running. The only way to unplug it
properly on a Linux system, as to my knowledge, is to echo `suspend'
to `/sys/bus/usb/devices/$DEV/power/level'. And one has to have
CONFIG_USB_SUSPEND=y to do this.
On Windows and Mac OS, `safely remove this device' function effectly
turns it into `suspend' mode, and it's light off.
I'm new in this field and I understood people's concern on enabling
autosuspend. As to my understanding, `enabling suspend' and `enabling
autosuspend' should be controlled by two different knobs. I did a
quick search in LKML and haven't found specific oppose to enable USB
suspend by default, and Debian has started shipping a kernel with
it turned on since 2.6.26.
Perhaps we should consider turning it on by default? Thanks!
It's probably not a bad idea. I'm not sure how big of a problem it
actually is, though. As long as the filesystem is unmounted before
unplug you'll probably be OK (unless you ripped out the cable/power so
quickly afterwards that there was still data in the write cache).
Ideally before disconnecting a removable hard drive one should flush the
write cache and park the heads (the latter being somewhat important for
2.5" drives in order to avoid emergency head unloads that would reduce
the life of the drive). I believe that there's a command one can echo
into the sd driver in sysfs somewhere that will trigger this.. Therefore
the right sequence would be:
-unmount filesystem
-remove SCSI disk (synchronize cache and stop unit)
-suspend SCSI device
Thing is that some USB storage devices don't support both of those
commands (I've got a USB-to-IDE enclosure with a Genesys chipset that
doesn't translate SCSI START STOP UNIT into an IDE Standby Immediate
command as it really should, think it just throws "invalid field in CDB"
errors). However if we've done the above we've really done the best we
can do..
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
