On Wed, 2 Dec 2015, Al Cooper wrote:
> Currently usb_port_resume waits for up to 2 seconds for CONNECT
> status for SS devices only. This change will do the same thing for
> non-SS devices even though the reason is a little different. This
> will fix an issue where VBUS is turned off during system wide
> "suspend to ram" and some 2.0 devices take greater than the current
> max of 100ms to show connected after VBUS is enabled. This is most
> commonly seen on hard drive based devices and USB3.0 devices plugged
> into a 2.0 only port.
>
> Signed-off-by: Al Cooper <alcooperx@xxxxxxxxx>
> ---
> drivers/usb/core/hub.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
> index bdeadc1..d32824b 100644
> --- a/drivers/usb/core/hub.c
> +++ b/drivers/usb/core/hub.c
> @@ -3322,7 +3322,7 @@ static int finish_port_resume(struct usb_device *udev)
> * This routine should only be called when persist is enabled for a SS
> * device.
> */
> -static int wait_for_ss_port_enable(struct usb_device *udev,
> +static int wait_for_connected(struct usb_device *udev,
> struct usb_hub *hub, int *port1,
> u16 *portchange, u16 *portstatus)
> {
Please update the comments at the head of this routine to match.
Alan Stern
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
