From: Reinder de Haan <patchesrdh@xxxxxxxxx>
Note this commit only adds support for phys 1-3, phy 0, the otg phy, is
not yet (fully) supported after this commit.
Signed-off-by: Reinder de Haan <patchesrdh@xxxxxxxxx>
Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
Changes in v2:
-Change break; after dev_err() to return, as intended, fixing a compiler
warning (the dev_err case should never be reached)
Changes in v3:
-Use of_match_node to get model specific config data
---
.../devicetree/bindings/phy/sun4i-usb-phy.txt | 1 +
drivers/phy/phy-sun4i-usb.c | 46 +++++++++++++++++-----
2 files changed, 38 insertions(+), 9 deletions(-)
diff --git a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
index 0cebf74..95736d7 100644
--- a/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
+++ b/Documentation/devicetree/bindings/phy/sun4i-usb-phy.txt
@@ -9,6 +9,7 @@ Required properties:
* allwinner,sun7i-a20-usb-phy
* allwinner,sun8i-a23-usb-phy
* allwinner,sun8i-a33-usb-phy
+ * allwinner,sun8i-h3-usb-phy
- reg : a list of offset + length pairs
- reg-names :
* "phy_ctrl"
diff --git a/drivers/phy/phy-sun4i-usb.c b/drivers/phy/phy-sun4i-usb.c
index 1d8f85d..2aed482 100644
--- a/drivers/phy/phy-sun4i-usb.c
+++ b/drivers/phy/phy-sun4i-usb.c
@@ -46,6 +46,9 @@
#define REG_PHYBIST 0x08
#define REG_PHYTUNE 0x0c
#define REG_PHYCTL_A33 0x10
+#define REG_PHY_UNK_H3 0x20
+
+#define REG_PMU_UNK_H3 0x10
#define PHYCTL_DATA BIT(7)
@@ -79,7 +82,7 @@
#define PHY_DISCON_TH_SEL 0x2a
#define PHY_SQUELCH_DETECT 0x3c
-#define MAX_PHYS 3
+#define MAX_PHYS 4
/*
* Note do not raise the debounce time, we must report Vusb high within 100ms
@@ -91,6 +94,7 @@
enum sun4i_usb_phy_type {
sun4i_a10_phy,
sun8i_a33_phy,
+ sun8i_h3_phy,
};
struct sun4i_usb_phy_cfg {
@@ -101,6 +105,7 @@ struct sun4i_usb_phy_cfg {
};
struct sun4i_usb_phy_data {
+ struct device *dev;
void __iomem *base;
const struct sun4i_usb_phy_cfg *cfg;
struct mutex mutex;
@@ -183,6 +188,9 @@ static void sun4i_usb_phy_write(struct sun4i_usb_phy *phy, u32 addr, u32 data,
/* A33 needs us to set phyctl to 0 explicitly */
writel(0, phyctl);
break;
+ case sun8i_h3_phy:
+ dev_err(phy_data->dev, "H3 usb_phy_write is not supported\n");
+ return;
}
for (i = 0; i < len; i++) {
@@ -243,6 +251,7 @@ static int sun4i_usb_phy_init(struct phy *_phy)
struct sun4i_usb_phy *phy = phy_get_drvdata(_phy);
struct sun4i_usb_phy_data *data = to_sun4i_usb_phy_data(phy);
int ret;
+ u32 val;
ret = clk_prepare_enable(phy->clk);
if (ret)
@@ -254,16 +263,26 @@ static int sun4i_usb_phy_init(struct phy *_phy)
return ret;
}
- /* Enable USB 45 Ohm resistor calibration */
- if (phy->index == 0)
- sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, 0x01, 1);
+ if (data->cfg->type == sun8i_h3_phy) {
+ if (phy->index == 0) {
+ val = readl(data->base + REG_PHY_UNK_H3);
+ writel(val & ~1, data->base + REG_PHY_UNK_H3);
+ }
- /* Adjust PHY's magnitude and rate */
- sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, 0x14, 5);
+ val = readl(phy->pmu + REG_PMU_UNK_H3);
+ writel(val & ~2, phy->pmu + REG_PMU_UNK_H3);
+ } else {
+ /* Enable USB 45 Ohm resistor calibration */
+ if (phy->index == 0)
+ sun4i_usb_phy_write(phy, PHY_RES45_CAL_EN, 0x01, 1);
- /* Disconnect threshold adjustment */
- sun4i_usb_phy_write(phy, PHY_DISCON_TH_SEL,
- data->cfg->disc_thresh, 2);
+ /* Adjust PHY's magnitude and rate */
+ sun4i_usb_phy_write(phy, PHY_TX_AMPLITUDE_TUNE, 0x14, 5);
+
+ /* Disconnect threshold adjustment */
+ sun4i_usb_phy_write(phy, PHY_DISCON_TH_SEL,
+ data->cfg->disc_thresh, 2);
+ }
sun4i_usb_phy_passby(phy, 1);
@@ -555,6 +574,13 @@ static const struct sun4i_usb_phy_cfg sun8i_a33_cfg = {
.dedicated_clocks = true,
};
+static const struct sun4i_usb_phy_cfg sun8i_h3_cfg = {
+ .num_phys = 4,
+ .disc_thresh = 3,
+ .type = sun8i_h3_phy,
+ .dedicated_clocks = true,
+};
+
static const struct of_device_id sun4i_usb_phy_of_match[] = {
{ .compatible = "allwinner,sun4i-a10-usb-phy", .data = &sun4i_a10_cfg },
{ .compatible = "allwinner,sun5i-a13-usb-phy", .data = &sun5i_a13_cfg },
@@ -562,6 +588,7 @@ static const struct of_device_id sun4i_usb_phy_of_match[] = {
{ .compatible = "allwinner,sun7i-a20-usb-phy", .data = &sun7i_a20_cfg },
{ .compatible = "allwinner,sun8i-a23-usb-phy", .data = &sun8i_a23_cfg },
{ .compatible = "allwinner,sun8i-a33-usb-phy", .data = &sun8i_a33_cfg },
+ { .compatible = "allwinner,sun8i-h3-usb-phy", .data = &sun8i_h3_cfg },
{ },
};
MODULE_DEVICE_TABLE(of, sun4i_usb_phy_of_match);
@@ -595,6 +622,7 @@ static int sun4i_usb_phy_probe(struct platform_device *pdev)
mutex_init(&data->mutex);
INIT_DELAYED_WORK(&data->detect, sun4i_usb_phy0_id_vbus_det_scan);
dev_set_drvdata(dev, data);
+ data->dev = dev;
data->cfg = match->data;
res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "phy_ctrl");
--
2.5.0
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
