From: Rajmohan Mani <rajmohan.mani@xxxxxxxxx> Existing Intel xHCI controllers require a delay of 1 mS, after setting the CMD_RESET bit in command register, before accessing any HC registers. This allows the HC to complete the reset operation and be ready for HC register access. Without this delay, the subsequent HC register access, may result in a system hang, very rarely. Verified CherryView / Braswell platforms go through over 5000 warm reboot cycles (which was not possible without this patch), without any xHCI reset hang. Signed-off-by: Rajmohan Mani <rajmohan.mani@xxxxxxxxx> Tested-by: Joe Lawrence <joe.lawrence@xxxxxxxxxxx> Cc: stable <stable@xxxxxxxxxxxxxxx> Signed-off-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx> --- drivers/usb/host/xhci.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index 6e7dc6f..dfa44d3 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -175,6 +175,16 @@ int xhci_reset(struct xhci_hcd *xhci) command |= CMD_RESET; writel(command, &xhci->op_regs->command); + /* Existing Intel xHCI controllers require a delay of 1 mS, + * after setting the CMD_RESET bit, and before accessing any + * HC registers. This allows the HC to complete the + * reset operation and be ready for HC register access. + * Without this delay, the subsequent HC register access, + * may result in a system hang very rarely. + */ + if (xhci->quirks & XHCI_INTEL_HOST) + udelay(1000); + ret = xhci_handshake(&xhci->op_regs->command, CMD_RESET, 0, 10 * 1000 * 1000); if (ret) -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
