Set the Power register HSENAB bit based on musb->config->maximum_speed,
so that the glue layer can control MUSB to work in high- or full-speed.
Signed-off-by: Bin Liu <b-liu@xxxxxx>
---
drivers/usb/musb/musb_core.c | 16 ++++++++++------
include/linux/usb/musb.h | 2 +-
2 files changed, 11 insertions(+), 7 deletions(-)
diff --git a/drivers/usb/musb/musb_core.c b/drivers/usb/musb/musb_core.c
index 6dca3d7..e16451c 100644
--- a/drivers/usb/musb/musb_core.c
+++ b/drivers/usb/musb/musb_core.c
@@ -1014,18 +1014,22 @@ void musb_start(struct musb *musb)
{
void __iomem *regs = musb->mregs;
u8 devctl = musb_readb(regs, MUSB_DEVCTL);
+ u8 power;
dev_dbg(musb->controller, "<== devctl %02x\n", devctl);
musb_enable_interrupts(musb);
musb_writeb(regs, MUSB_TESTMODE, 0);
- /* put into basic highspeed mode and start session */
- musb_writeb(regs, MUSB_POWER, MUSB_POWER_ISOUPDATE
- | MUSB_POWER_HSENAB
- /* ENSUSPEND wedges tusb */
- /* | MUSB_POWER_ENSUSPEND */
- );
+ power = MUSB_POWER_ISOUPDATE;
+ /*
+ * treating UNKNOWN as unspecified maximum speed, in which case
+ * we will default to high-speed.
+ */
+ if (musb->config->maximum_speed == USB_SPEED_HIGH ||
+ musb->config->maximum_speed == USB_SPEED_UNKNOWN)
+ power |= MUSB_POWER_HSENAB;
+ musb_writeb(regs, MUSB_POWER, power);
musb->is_active = 0;
devctl = musb_readb(regs, MUSB_DEVCTL);
diff --git a/include/linux/usb/musb.h b/include/linux/usb/musb.h
index a4ee1b5..fa6dc13 100644
--- a/include/linux/usb/musb.h
+++ b/include/linux/usb/musb.h
@@ -95,7 +95,7 @@ struct musb_hdrc_config {
/* musb CLKIN in Blackfin in MHZ */
unsigned char clkin;
#endif
-
+ u32 maximum_speed;
};
struct musb_hdrc_platform_data {
--
1.8.4
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
