在 2015/8/14 8:09, John Youn 写道:
On 8/11/2015 12:57 AM, Yunzhi Li wrote:
We initiate dwc2 usb controller in BIOS, when kernel driver
start-up we should reset AHB hclk domain to reset all AHB
interface registers to default. Without this the FIFO value
setting might be incorrect because calculating FIFO size need the
power-on value of GRXFSIZ/GNPTXFSIZ/HPTXFSIZ registers.
This patch could avoid warnning massage like in rk3288 platform:
[ 2.074764] dwc2 ff580000.usb: 256 invalid for
host_perio_tx_fifo_size. Check HW configuration.
......
I didn't receive the other two patches in this series so I was
confused about where the "ahb_reset" was coming from when I
replied to your other patch.
I see you changed the name and documented the DT so never mind.
Another thing is that there probably shouldn't be a debug
message on the IS_ERR condition since that is the common case
and of no interest to other platforms.
The other two resets you added aren't used by the driver
anywhere right? Maybe those should be left out until they are.
John
Hi John ,
Here is the other two patches :
https://patchwork.kernel.org/patch/6989541/
https://patchwork.kernel.org/patch/6989531/
ahb_reset is hreset_n signal of dwc2 IP. Our rk3288 SoC implement
connect this signal to a special
register in clock ang reset unit (CRU) module, set this register will
reset dwc2 control and status registers(CSR)
to default value. You could find more info in <<DesignWare Cores USB 2.0
Hi Speed On-TheGo (OTG) Databook 3.10a>>
4.4.1 System Clock and Reset Signals.
Our problem is that dwc2_get_hwparams() reads fifo size registers and
reguards it as the power-on reset value,
then dwc2_set_param_host_perio_tx_fifo_size() will check this value and
make sure the new fifo size value is no bigger
than the power-on reset value. But we init and set these fifo registers
in BIOS, so here hw->xxx_fifo_size is not the
real power-on reset vaule. So we hope to reset CSR before
dwc2_get_hwparams().
I have another ideal: we might use GRSTCTL.CSftRst instead of hreset_n
to reset dwc2 CSR.
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
